Micronics manual Quick Installation, Installing the W6-LI

Page 11

Chapter 1: Quick Installation

Chapter

1

Quick Installation

We know that many experienced people prefer to read as little of the documentation as possible. If this sounds like you, here’s the short form to get up and running quickly.

STATIC!

Before handling the W6-LI, be properly grounded by using a special wrist or ankle strap, or touch a safely grounded object.

Installing the W6-LI

1.Make backup copies of your installation and configu- ration diskettes.

2.Ground yourself to prevent damaging static dis- charge, then remove the W6-LI from its packaging.

3.Configure and verify the system board’s jumper set- tings (refer to Jumper Settings in Chapter 2).

4.Install the CPU and the system memory (refer to Chapter 3).

5.Install the system board into the chassis and make all necessary case connections.

6.Install any ISA and/or PCI add-on peripherals (refer to Chapter 3).

7.Now you can connect any optional devices (refer to Chapter 3).

8.Turn the computer on and press the <F2> key when you see the screen in Figure 1.1.

W6-LI System Board Manual

9

Image 11

Contents PCI/ISA Copyright Notices Table of Contents Installing Device Drivers Glossary Index List of Figures Introduction Features IBM Software CompatibilityCommon Names Before You BeginInstalling the W6-LI Quick InstallationPower-Up Screen Static Electricity Configuring the W6-LIW6-LI System Board W6-LI System BoardCPU Jumper SettingsFunction Settings Disable Scsi 9B Case & Peripheral Connections Introduction Installing the W6-LIATX chassis with standard hardware System Memory Installing the W6-LI Memory Configurations Memory Bank Bank 256MB Removing DIMMs Installing the DIMMsInstalling a CPU Installing a PCI Card Installing a PCI Peripheral CardInstalling an ISA Card Installing an ISA Peripheral CardInstalling a CD-ROM Drive W6-LI Sound Option Connecting Sound DevicesLine Game PortLine Out Connecting the Scsi Option Setup Bios Setup UtilityPower-Up Screen Setting the Main Screen Running the Setup ProcedureNumlock Video BiosSystem Time and Date Diskette a or BExtended Memory System BiosSystem Memory Multiple-Sector Transfers TypeSmart Monitoring LBA Mode ControlTransfer Mode Bit I/OSerial Port B Setting the Advanced ScreenSerial Port a Integrated PCI IDE Use MP SpecificationParallel Port Floppy Disk ControllerLarge Disk Access Mode Reset Configuration DataPCI Configuration Secured Setup ConfigurationSecurity Screen Set Supervisor PasswordSupervisor Password Submenu Set User PasswordDiskette Access Password on BootFixed Disk Boot Sector Power Management Power ScreenAuto Suspend Timeout Standby TimeoutPost Errors Boot ScreenHard Drive Boot Order Setup PromptFloppy Check Exit ScreenTheBIOSSetupUtility W6-LI System Board Manual Installing the Sound Drivers Installing Device DriversInstalling the Scsi Drivers Bios SpecificationsScsi Environmental SpecificationsBattery Disposal Technical Support Support and Information ServicesService Hours Country Appendix a Technical Information W6-LI System Board Manual Post Messages Message Possible Cause SolutionCmos Beep and Post Codes Get in Post Reg Code One beep Heads Write Sectors Size Hard Disk Drive TypesType Cylinders Heads Write Precomp Sectors Size 823 512 Appendix E Updating the System Bios Updating the System BiosPage Limited Warranty Non-Warranty Service FCC Statement DeclarationofConformity Glossary Internal Cache Cache which is built into the CPU. See Cache Small Computer System Interface Glossary ATX IndexPage