Micronics W6-LI manual Environmental Specifications, Scsi

Page 56

Appendix A: Technical Information

Onboard Sound:	Creative Labs VIBRA 16CL (optional)
Fast SCSI:	Adaptec 7880 Fast SCSI Bus Mastering controller
(optional)	Resident 50-pin SCSI connector
	Resident 68-pin SCSI connector (Ultra Wide
	SCSI).
Cache:	16K Level 1 Write Back on CPU chip
	256K/512K Level 2 cache in CPU package
I/O Ports:	Two high speed serial ports (16550 compatible)
	Enhanced Parallel Port with ECP and EPP support
	Two USB connectors (optional)
Floppy Port:	Auto-detection and support of two floppy drives
	(2.88MB, 1.44MB, 1.2MB, 720K, 360K).
PCI IDE Ports:	Mode 4 IDE
	Two resident 40-pin IDE connector
	Multiple sector transfer support
	Auto detection of add-in IDE board

Environmental Specifications

The environment in which the W6-LI is located is critical. Micronics recommends the following environmental specifications:

Temperature Range

Operating: 50 to 104 degrees Fahrenheit (10 to 40 degrees Celsius).

Non -Operating: 50 to 140 degrees Fahrenheit (10 to 60 degrees

Celsius). Shipping: -22 to 140 degrees Fahrenheit (-30 to 60 degrees Celsius).

Relative Humidity

Operating: 20% to 80%.

Non-Operating: 5% to 90%.

54	W6-LI System Board Manual

Image 56

Contents PCI/ISA Copyright Notices Table of Contents Installing Device Drivers Glossary Index List of Figures Introduction Features Software Compatibility IBMBefore You Begin Common NamesQuick Installation Installing the W6-LIPower-Up Screen Configuring the W6-LI Static ElectricityW6-LI System Board W6-LI System BoardJumper Settings CPUFunction Settings Disable Scsi 9B Case & Peripheral Connections Installing the W6-LI IntroductionATX chassis with standard hardware System Memory Installing the W6-LI Memory Configurations Memory Bank Bank 256MB Installing the DIMMs Removing DIMMsInstalling a CPU Installing a PCI Peripheral Card Installing a PCI CardInstalling an ISA Peripheral Card Installing an ISA CardInstalling a CD-ROM Drive Connecting Sound Devices W6-LI Sound OptionLine Game PortLine Out Connecting the Scsi Option Bios Setup Utility SetupPower-Up Screen Running the Setup Procedure Setting the Main ScreenVideo Bios System Time and DateDiskette a or B NumlockExtended Memory System BiosSystem Memory Type Multiple-Sector TransfersLBA Mode Control Transfer ModeBit I/O Smart MonitoringSerial Port B Setting the Advanced ScreenSerial Port a Use MP Specification Parallel PortFloppy Disk Controller Integrated PCI IDEReset Configuration Data PCI ConfigurationSecured Setup Configuration Large Disk Access ModeSet Supervisor Password Security ScreenSet User Password Supervisor Password SubmenuDiskette Access Password on BootFixed Disk Boot Sector Power Screen Power ManagementStandby Timeout Auto Suspend TimeoutBoot Screen Hard Drive Boot OrderSetup Prompt Post ErrorsExit Screen Floppy CheckTheBIOSSetupUtility W6-LI System Board Manual Installing Device Drivers Installing the Sound DriversInstalling the Scsi Drivers Specifications BiosEnvironmental Specifications ScsiBattery Disposal Support and Information Services Technical SupportService Hours Country Appendix a Technical Information W6-LI System Board Manual Message Possible Cause Solution Post MessagesCmos Beep and Post Codes Get in Post Reg Code One beep Hard Disk Drive Types Heads Write Sectors SizeType Cylinders Heads Write Precomp Sectors Size 823 512 Updating the System Bios Appendix E Updating the System BiosPage Limited Warranty Non-Warranty Service FCC Statement DeclarationofConformity Glossary Internal Cache Cache which is built into the CPU. See Cache Small Computer System Interface Glossary Index ATXPage