Chapter 2: Configuring the W6-LI
Table 2-3 lists the jumper settings for the ISA Bus clock frequency.
Jumper | Host Bus Speed | ISA Bus Speed | Setting |
| | | |
W12 | 60MHz (default) | 7.50MHz | Close |
| 66MHz (default) | 8.25MHz | Close |
| | | |
Table 2-3: ISA BUS Clock Settings
Table 2-4 lists the jumper settings to enable or disable the system power supply.
Jumper | Function | Settings |
| | |
W13 | Normal (default) | Open |
| Reserved | Close |
| | |
Table 2-4: System Power Supply Setting
Table 2-5 lists the jumper settings to clear the CMOS settings. With your computer's power off, close pins 2-3, wait ten seconds and place the jumper back on pins 1-2. (The jumper must be placed back on pins 1-2 for the system to function properly.)
NOTE: This will reset all BIOS default settings. Any changes you have made will be lost.
Jumper | Function | Settings |
| | |
W11 | Normal (default) | 1-2 |
| Clear CMOS | 2-3 |
| | |
Table 2-5: Clear CMOS Settings
Table 2-6 lists the jumper settings to select the optional onboard sound.
Jumper | Function | Settings |
| | |
W14 | Enable Sound (default) | Close |
| Disable Sound | Open |
| | |
Table 2-6: Onboard Sound Selection
14 | W6-LI System Board Manual |
