Micronics W6-LI manual FCC Statement

Page 73

Appendix F: Warranties and Notices

FCC Statement

This equipment has been tested and found to comply within the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter- ference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not used in accordance with the instructions, may cause harmful interference to radio communications. Interference to radio or television reception can be determined by turning the equipment off and on. You are encouraged to try to correct the interference by one or more of the following measures:

▲Reorient the receiving antenna.

▲Increase the separation between the equipment and the receiver.

▲Connect the equipment into an outlet on a circuit different from that to which the receiver is con- nected.

▲Consult your dealer or an experienced radio/TV technician for help.

To meet FCC requirements, shielded cables are required.

NOTE: Changes or modifications not expressly approved by Micronics could void your authority to operate the equipment.

W6-LI System Board Manual

71

Image 73

Contents PCI/ISA Copyright Notices Table of Contents Installing Device Drivers Glossary Index List of Figures Introduction Features IBM Software CompatibilityCommon Names Before You BeginInstalling the W6-LI Quick InstallationPower-Up Screen Static Electricity Configuring the W6-LIW6-LI System Board W6-LI System BoardCPU Jumper SettingsFunction Settings Disable Scsi 9B Case & Peripheral Connections Introduction Installing the W6-LIATX chassis with standard hardware System Memory Installing the W6-LI Memory Configurations Memory Bank Bank 256MB Removing DIMMs Installing the DIMMsInstalling a CPU Installing a PCI Card Installing a PCI Peripheral CardInstalling an ISA Card Installing an ISA Peripheral CardInstalling a CD-ROM Drive W6-LI Sound Option Connecting Sound DevicesLine Out Game PortLine Connecting the Scsi Option Setup Bios Setup UtilityPower-Up Screen Setting the Main Screen Running the Setup ProcedureSystem Time and Date Video BiosDiskette a or B NumlockSystem Memory System BiosExtended Memory Multiple-Sector Transfers TypeTransfer Mode LBA Mode ControlBit I/O Smart MonitoringSerial Port a Setting the Advanced ScreenSerial Port B Parallel Port Use MP SpecificationFloppy Disk Controller Integrated PCI IDEPCI Configuration Reset Configuration DataSecured Setup Configuration Large Disk Access ModeSecurity Screen Set Supervisor PasswordSupervisor Password Submenu Set User PasswordFixed Disk Boot Sector Password on BootDiskette Access Power Management Power ScreenAuto Suspend Timeout Standby TimeoutHard Drive Boot Order Boot ScreenSetup Prompt Post ErrorsFloppy Check Exit ScreenTheBIOSSetupUtility W6-LI System Board Manual Installing the Sound Drivers Installing Device DriversInstalling the Scsi Drivers Bios SpecificationsScsi Environmental SpecificationsBattery Disposal Technical Support Support and Information ServicesService Hours Country Appendix a Technical Information W6-LI System Board Manual Post Messages Message Possible Cause SolutionCmos Beep and Post Codes Get in Post Reg Code One beep Heads Write Sectors Size Hard Disk Drive TypesType Cylinders Heads Write Precomp Sectors Size 823 512 Appendix E Updating the System Bios Updating the System BiosPage Limited Warranty Non-Warranty Service FCC Statement DeclarationofConformity Glossary Internal Cache Cache which is built into the CPU. See Cache Small Computer System Interface Glossary ATX IndexPage