Micronics W6-LI manual Cmos

Appendix B: POST Messages

Message	Possible Cause	Solution
MONITOR TYPE	Monitor type not	Run Setup and enter
DOES NOT MATCH	correctly identified in	correct monitor type.
CMOS	Setup.
OPERATING	Operating system	Check Setup to see if
SYSTEM NOT	cannot be located on	Drive A: and C: are
FOUND	Drive C: or Drive A:	properly configured, or
		put a bootable disk in
		Drive A:
PARITY CHECK 1	Parity error found in the	Check Setup. Board
nnnn	system bus.	repair may be required.
PARITY CHECK 2	Parity error found in the	Check Setup. Board
nnnn	I/O bus.	repair may be required.
PREVIOUS BOOT	Previous POST did not	Run Setup, load default
INCOMPLETE -	complete successfully.	BIOS settings, make any
DEFAULT		necessary adjustments,
CONFIGURATION		and save the changes
USED
REAL TIME CLOCK	Real-time clock failed	May require battery
ERROR	BIOS test.	replacement or board
		repair.
SHADOW RAM	Shadow RAM failed.	May require repair of
FAILED AT OFFSET		system board.
SYSTEM BATTERY	System battery died.	Replace the system
IS DEAD		battery and run Setup to
		reconfigure the system.
SYSTEM CACHE	External (L2) cache	System will still run, but
ERROR - CACHE	failed BIOS test.	slower. Replace cache
DISABLED		at convenience.
SYSTEM CMOS	System CMOS has been	Run Setup and
CHECKSUM BAD -	corrupted or modified	reconfigure the system.
RUN SETUP	incorrectly.
SYSTEM RAM	System RAM failed.	Replace defective RAM.
FAILED AT
OFFSET: nnnn
SYSTEM TIMER	Timer test failed.	Requires repair of system
ERROR		board.

60 W6-LI System Board Manual