Forward-Facing Installation with Vehicle Belts:
1 | Connect and tighten |
harness straps prior to | |
| installing in vehicle. |
Place child restraint flush against the back of the vehicle seat forward- facing in the back seat.
Thread the vehicle lap belt or lap/shoulder belt combination through the belt path and out other side. Buckle.
4 |
With weakest hand at belt path, tilt and push the child restraint forward and back, and from side to side. If the seat belts do not loosen, your child restraint should be secure.
NOTE: Some “play” from front to back or about an inch from side to side is acceptable. If it moves more, review “Knowing Your Vehicle Belts” and “The Locking Clip” sections.
2 |
3 |
Place one knee in the child restraint and push down firmly while pulling up on belt to tighten. For a manual belt, refer to “Knowing your Vehicle Belt” section.
With knee still in child restraint, attach hook to anchor in vehicle. Push down firmly and tighten top anchorage strap.
!WARNING
Using this child restraint in any vehicle seat where the lap belt cannot be tightened securely and properly or where it can be loosened by pulling on it can result in serious injury or death.
5 | After checking for hot |
seat and buckles, place | |
| your child in the child |
| restraint as described |
| in the “Securing Your |
| Child in the Child |
| Restraint” section. |
To adjust top anchorage strap: See “Adjusting Top Anchorage Strap” section.
NOTE: If your vehicle does not have an anchor bracket, tuck the top anchorage strap’s hook under the child restraint.
22
23