Dorel Eng. 4358-5936 manual Install Cup Holder on select models, Check Harness Height, Front

Page 8

5

6

Harness

Guide

Place the child’s bottom and back flat against the child restraint. This will increase comfort and allow the harness to properly tighten.

Check Harness Height

Forward-Facing Position: Harness guide must be even with or just above the shoulders.

If the top harness guides are below the child’s shoulders, the child weighs at least 40 lbs. (18.1

	9	Pull harness through the
	9	harness guides from the
		harness guides from the
		front.

Rethread harness into new harness guide location. Refasten harness to splitter plate. Make sure harness does not twist.

!WARNING

Failure to reattach the harness correctly can result in serious injury or death.

Install Cup Holder (on select models)

kg) and is over 1 year old, convert the seat to a belt- positioning booster.

1

Pull pad off corner. Hook bottom of cup holder on bottom edge of child restraint and rotate cup holder up.

7

8

Determine which set of harness guide slots works best for your child. Adjust if needed.

To change harness location:

From the back of the seat, remove harness from splitter plate.

2

Snap top of cup holder on top edge of child restraint. Make certain cup holder is flush on the top and sides of child restraint. Replace pad.

12

13

Image 8

Contents Commuter/Ventura High Back Booster Table of Contents Before You BeginPage Aircraft Installation General and Warm Weather UseUnderstanding Your Vehicle Anchor Bracket Air BagLatch Anchors Seat BightChild Restraint Parts Front BackChoosing Restraint and Position Preparing Child Restraint to Fit Your ChildMake sure Latch belt Child restraint shellInstall Cup Holder on select models Check Harness HeightFront To change harness locationSecuring Your Child in the Child Restraint Down on the harness Out on the harnessPress red button on Buckle to releaseManual Belts Knowing Your Vehicle BeltsVehicle belt too short Year of age Forward-Facing Use Forward-Facing Installation43 85.1-110 cm, Over 1 year of age Forward-Facing Installation with Vehicle Belts Age To Attach Top Anchorage Strap Adjusting the Top Anchorage StrapStorage of Top Anchorage Strap Belt-Positioning Booster Use Removal of HarnessBelt-Positioning Booster Installation Reinstall Harness Stops against the shellRemoving Seat Pad for Cleaning Remove harness asPositioning Booster Straps shown in redLocking Clip Remove the 6 harnessOut from the front side With the otherTrouble Shooting Warranty Replacement Parts Order Form