Dorel Eng. 4358-5936 manual Knowing Your Vehicle Belts, Vehicle belt too short, Manual Belts

Page 11

Knowing Your Vehicle Belts

Not all vehicle belts will work with this child restraint. You must determine if your vehicles belts are compatible with this child restraint. If you will use the LATCH system, refer to the LATCH section.

ELR - Emergency Locking Retractor Belts Definition: These belts only lock in a sudden stop or crash. To see if you have this type of belt, pull on the lap belt, let it return part way, then pull on it again. If it moves freely, it is an ELR belt and the child restraint could work loose during normal driving. Refer to your vehicle owner’s manual.

ELR shoulder belts either require a locking clip or cannot be used with any child restraint. Note: You may use an ELR lap and shoulder belt when using this child restraint as belt-positioning booster; no locking clip is required.

ELR lap-only belts must be replaced with a manual belt; contact your vehicle dealer. A locking clip will not correct this problem.

Automatic/Passive vehicle seat belts Automatic (passive) 2-point belt has no lap belt. You must install a lap belt to secure a child restraint. You may also need to install an extra lap belt for an automatic 3-point belt. Refer to the vehicles owner’s manual. A locking clip will not correct this problem.

Vehicle belt too short

Contact your vehicle dealer for a seat belt extender.

Belts in center of the door or side panel (A) or middle of the vehicle seat cushion (B).

1

2

Buckle plate

Buckle

Twist vehicle seat belt

and latch plate (or buckle)

Manual Belts

Manual lap belts are common in the center rear seat and can allow the child restraint to loosen when it is tilted or jarred. After tightening the lap belt securely, tilt and push the child restraint forward and to both sides. If no loosening occurs, your child restraint should be secure.

If loosening does occur, try the following: If the buckle plate slides on the belt, turn the buckle plate over. If the buckle slides, turn the buckle. Refasten the vehicle lap belt. The release button should face out after twisting so that it is easy to reach in an emergency.

If the lap belt continues to loosen, the child restraint must be moved to another location in the vehicle. A locking clip will not correct this problem; see your vehicle owner’s manual.

 

 

 

You must move the child

A

 

B

 

restraint to another seating

 

 

 

 

 

 

location. A locking clip will

 

 

 

not fix this problem.

 

 

 

See “Locking Clip” section.

 

 

 

 

!WARNING

Failure to check and adjust the manual belt as described above can result in serious injury or death.

18

19

Image 11
Contents Commuter/Ventura High Back Booster Before You Begin Table of ContentsPage General and Warm Weather Use Aircraft InstallationSeat Bight Understanding Your VehicleAnchor Bracket Air Bag Latch AnchorsFront Back Child Restraint PartsChild restraint shell Choosing Restraint and PositionPreparing Child Restraint to Fit Your Child Make sure Latch beltTo change harness location Install Cup Holder on select modelsCheck Harness Height FrontSecuring Your Child in the Child Restraint Buckle to release Down on the harnessOut on the harness Press red button onManual Belts Knowing Your Vehicle BeltsVehicle belt too short Year of age Forward-Facing Use Forward-Facing Installation43 85.1-110 cm, Over 1 year of age Forward-Facing Installation with Vehicle Belts Age To Attach Top Anchorage Strap Adjusting the Top Anchorage StrapStorage of Top Anchorage Strap Removal of Harness Belt-Positioning Booster UseBelt-Positioning Booster Installation Stops against the shell Reinstall HarnessStraps shown in red Removing Seat Pad for CleaningRemove harness as Positioning BoosterWith the other Locking ClipRemove the 6 harness Out from the front sideTrouble Shooting Replacement Parts Order Form Warranty