Dorel Eng. 4358-5936 manual Age

Page 14

Forward-Facing Installation with LATCH Belt: Install LATCH Belts

Fasten one LATCH belt hook to the anchor in the vehicle seat located in the vehicle seat bight.

Forward-

1

2

NOTE: Do not use LATCH system along with the adult lap or lap/ shoulder belt.

Route LATCH belt through upper slot in side of shell.

Pull one LATCH hook across the back and out the other side.

The LATCH adjuster can be on either side, but the belt should not be twisted.

Repeat for other side of child restraint. See your vehicle owner’s manual for locations and more information.

Place one knee in the child restraint and push down firmly while pulling up on the loop to tighten belt.

Facing Use: 22-40 lbs. (10.1-18 kg), 34-43” (85.1-110 cm), Over 1 year

3

Connect and tighten

harness straps prior to

 

 

installing in vehicle.

Place child restraint flush against the back of the vehicle seat forward- facing in the back seat.

5

6

With knee still in child restraint, attach hook to anchor in vehicle. Push down firmly and tighten top anchorage strap.

To adjust top anchorage strap: See “Adjusting Top Anchorage Strap” section.

of age.

24

25continued on next page.

Image 14
Contents Commuter/Ventura High Back Booster Table of Contents Before You BeginPage Aircraft Installation General and Warm Weather UseLatch Anchors Understanding Your VehicleAnchor Bracket Air Bag Seat BightChild Restraint Parts Front BackMake sure Latch belt Choosing Restraint and PositionPreparing Child Restraint to Fit Your Child Child restraint shellFront Install Cup Holder on select modelsCheck Harness Height To change harness locationSecuring Your Child in the Child Restraint Press red button on Down on the harnessOut on the harness Buckle to releaseManual Belts Knowing Your Vehicle BeltsVehicle belt too short Year of age Forward-Facing Use Forward-Facing Installation43 85.1-110 cm, Over 1 year of age Forward-Facing Installation with Vehicle Belts Age To Attach Top Anchorage Strap Adjusting the Top Anchorage StrapStorage of Top Anchorage Strap Belt-Positioning Booster Use Removal of HarnessBelt-Positioning Booster Installation Reinstall Harness Stops against the shellPositioning Booster Removing Seat Pad for CleaningRemove harness as Straps shown in redOut from the front side Locking ClipRemove the 6 harness With the otherTrouble Shooting Warranty Replacement Parts Order Form