Using the Latch Connectors, Using the Versa-Tether

Child Seat Functions

Using the LATCH Connectors

The LATCH connectors are located on the sides of the shell in the storage slots. Store the LATCH connectors when not in use.

To remove the LATCH connector from the storage slot or lower anchor:

1 Press and hold the red release

button.

Tether anchor locations vary from vehicle to vehicle. Check your vehicle owner’s manual and look for the tether anchor symbol shown in the diagram to help identify where the top tether anchor point is located in your vehicle.

Child Seat Functions

2 Pull the LATCH connector

from the storage slot or lower

anchor.

To attach the LATCH connector to the storage slot or lower

anchor:Top

Firmly push the LATCH connector into the slot or lower anchor until a click is heard to store.

NOTE: The LATCH connectors store in the slots upside-down.

Using the Versa-Tether

WARNING!

•Attach the Versa-Tether only to tether anchors identified by your vehicle manufacturer as tether anchorage points.

•If your vehicle does not currently have a tether anchor attachment, refer to your vehicle owner’s manual or contact your vehicle manufacturer for assistance. DO NOT modify your vehicle without advice from your vehicle manufacturer.

When using the child seat in harness mode:

•Britax recommends that the tether be used at all times when installing the child seat. Using the tether will improve the stability of your child seat and reduce the risk of injury.

To remove the Versa-Tether from the storage clip:

1Remove the webbing from the

elastic strap and loosen the Versa-Tether.

2Remove the Versa-Tether®hook from the storage clip.

To attach the Versa-Tether to the storage clip or a tether anchor:

1Firmly press the hook over the storage clip or tether anchor point.

2 Always attach the hook over the anchor point.

	OR
IMPORTANT: Use the elastic strap
to contain extra webbing. Always
ensure any excess webbing is	OR
contained within your vehicle.