Lap Belt Short Path | Britax 85 SICT instruction

Installing the Child Seat: Harness Mode

1Rotate the positioning block to the front and place the child seat on the vehicle seat.

*Ensure harness height is adjusted to fit your child.

2Position the shoulder part of the vehicle belt behind the head restraint.

IMPORTANT: DO NOT route the vehicle belt under the cover or through the belt guide on the head restraint.

3Route the lap and shoulder parts of the vehicle belt over the lap belt guide, through the belt slot, across the back of the child seat shell, then through the second belt slot.

4Verify the vehicle belt is not twisted, then buckle.

5Push the child seat firmly into the vehicle seat while removing all slack from the lap part (a), then from the shoulder part (b) of the vehicle belt.

*Ensure that the vehicle belt is locked as directed by your vehicle owners manual.

*The child seat is secure when it cannot be moved front-to-back or side-to-side more than 1 in.

(2.5 cm) at the belt path. If the child seat is not secure, repeat the installation procedure or use a different seating location.

Lap Belt – Short Path

Before you begin:

99Check that your vehicle has a seat belt that can be locked.

*Check your vehicle owner’s manual to determine what type of vehicle belt you have and how it can be locked for use with child seats.

99Check that your vehicle has a top tether anchor?

*Britax recommends that the Versa-Tether is used at all times. Using the tether will improve the stability of the child seat and reduce the risk of injury. Check your vehicle owner’s manual for tether anchor locations.

99Remove the Versa-Tether®hook from the storage clip and place it over the child seat back to keep it from becoming pinned between the child seat and vehicle seat during installation.

Versa-Tether®

(Top Tether)

6Firmly press the Versa-Tether® hook to the vehicle tether anchor to attach. Remove all slack from the tether webbing.

7Use the elastic strap to contain extra webbing.

Checklist

99Check that positioning block is rotated to the front.

99Check all connections and verify that child seat is secure.

*The child seat is secure when it cannot be moved front-to- back or side-to-side more than 1 in. (2.5 cm) at the belt path. If the child seat is not secure, repeat the installation procedure or use a different seating location.

99Ensure any excess Versa-Tether®webbing is stored in elastic band. Always ensure any excess webbing is contained within your vehicle.

Install with the lap belt using only the short belt path as shown above.