Switching Between Modes
6Turn and slide the retainer through the slot to remove.
* Pull the harness webbing tight from the other side before pulling the retainer through.
Repeat steps 5 and 6 for the remaining harness buckle strap.
7 Remove the locking screw | Locking | |
from the head restraint | ||
Screw storage | ||
adjuster and insert into the | ||
| ||
shell to store. |
|
IMPORTANT: Store the screw in the slot provided in the shell. Store all parts of the harness in a safe place. These parts will be needed to convert the child seat back to harness mode.
Booster to Harness Mode
To replace the harness and buckle:
1 Move the harness adjuster to the highest position (a), then move the head restraint to the lowest position (b).
* Ensure that harness slots in | Locking |
the cover, head restraint and | |
harness adjuster are aligned. | Screw storage |
2 Replace the locking screw to lock the head restraint adjuster.
3Turn and slide the retainer of
the buckle strap through the buckle slot.
* Choose the slot that is closest to, but not under your child.
4Slide the retainer back into place to hold it against the
child seat shell. Verify that the strap is not twisted, and that the button faces out.
Switching Between Modes
5Turn and slide the retainer of each harness strap through the harness slot.
* Ensure that the icon on the chest clip faces out.
6Slide each retainer back into place on the child seat shell.
7Insert the harness straps through the slots in the cover,
shell, and harness adjuster to the back of the child seat.
8Remove the harness yoke
from storage on the belt shield (a), then remove the belt shield (b).
9 Nest the harness straps by inserting the right strap loop into the left strap loop.
10 Before reattaching the harness
straps, hold the harness yoke | Adjuster | |
as shown, and ensure that the | ||
Strap | ||
adjuster strap attached to the | ||
| ||
yoke is not twisted. |
|
11 Slide nested harness straps completely onto the harness yoke.
32 | 33 |