Britax 85 SICT manual Child seat in harness mode

Page 21

Securing Your Child

Harness Mode

WARNING!

• Never route the vehicle belt over the child when using this

child seat in harness mode.

• Adjust the belts provided with this child seat so they

Securing Your Child

4 Place the child in the child seat and position the harness straps around the child.

5 Fasten the harness buckle.

*Proper connection is confirmed with an audible click after

inserting each buckle tongue.

fit snugly around your child. A snug strap should not

allow any slack. It lies in a relatively straight line without

sagging. It does not press on the child’s flesh or push the

child’s body into an unnatural position.

• The HUGS™ chest pads must be used at all times.

• Adjust the harness to fit the clothes the child is wearing.

Remove bulky coats and/or jackets before putting the

child in the child seat.

• Verify that the child seat is secure and the harness is

properly adjusted around the child each time the child

seat is used.

6Pull the harness adjuster strap to tighten the harness.

*The harness should have a comfortable but snug fit around the child. A snug strap should not allow any slack. It lies in a relatively straight line without sagging. It does not press on the child’s flesh or push the child’s body into an unnatural position. You should not be able to pinch excess.

Pull the harness adjuster away from the child seat (parallel to the ground) to tighten.

Do not pull sideways.

Before you begin:

Always check the seat area for debris and remove it to prevent interference with the harness adjuster mechanism.

1Loosen the harness.

a Press release lever

b Pull both harness straps forward

2Open the chest clip.

a Press tabs b Pull apart

3Release the buckle and place the harness straps around the

armrests.

7Fasten the chest clip.

* The correct height for the chest

clip is at the middle of the

7

chest at armpit level.

 

* The HUGSchest pads may

 

be placed in any position

 

that is comfortable for the

 

child within the range of the

 

correctly placed chest clip.

 

Checklist

Before traveling, verify that the:

99Harness straps are not twisted.

99Harness is snug.

99Buckle is fastened.

99Chest clip is at the child’s armpit level.

38

39

Image 21
Contents Frontier 85 Sict Table of Contents Important Notes CertificationRegistration Child Seat Features Booster Mode Harness ModeWebbing Compatible Vehicle Seat Belts Lap-Shoulder 3-Point BeltLap Belt Incompatible Vehicle Seat BeltsVehicle Buckle Positions Vehicle Seating Positions Harness Mode Harness Height AdjustmentBooster Mode Head Restraint Adjustment Adjusting Buckle Position Removing the BuckleRe-threading the Buckle Using Lower Anchors and Tethers for Children Latch Using the Chest ClipUsing the Positioning Block Fastening the Buckle Releasing the BuckleUsing the Latch Connectors Using the Versa-TetherTo remove the Versa-Tether from the storage clip General Information Booster mode with children whoLatch Short Path ChecklistShort lap-shoulder belt path installation Lap-Shoulder Belt Selecting a Belt PathLap-Shoulder Belt Short Path Lap-Shoulder Belt Long Path Long lap-shoulder belt path installationLap Belt Short Path Harness to Booster Mode To remove the harness and buckle Switching Between ModesTurn and slide the retainer through the slot to remove Booster to Harness Mode To replace the harness and bucklePositioning the Child Seat Booster Mode Lap-Shoulder Belt Using LatchChild seat in harness mode Remove slack from the vehicle belt Cover Removal Cleaning the Harness Cleaning the CoverCleaning the Shell Cleaning the Side Impact CushionsTo Clean Cleaning the BuckleBuckle Replacement Buckle RemovalEnergy-Absorbing Tether TroubleshootingLimited ONE-YEAR Warranty Page Britax Child Safety, Inc