Graco 8A12BKR To Install Locking Clip do not use with base, Inch, Does not move by pulling

•CombinationLap/Shoulder Belt with Sliding Latch Plate

Locking clip

This belt has a latch plate that slides freely along the belt.

This belt MUST be converted to prevent movement of the lap portion of the belt. You must use a locking clip (provided with the infant restraint) when using the infant restraint without the base unless your vehicle's seat belt can be converted in another way as described in your vehicle owner's manual.

To Install Locking Clip: (DO NOT use with base)			1/2 inch
1.	Tighten the buckled belt by pushing down		(1 cm)
	hard on the infant restraint and pulling hard		➊
	on the shoulder belt.
2.	While pushing down on infant restraint, pinch
	the two straps together behind the buckle		➋
	tongue. Unbuckle the belt
	without allowing it to slip.
3.	Connect lap and shoulder belts
	with locking clip as shown ➊
	and ➋.
4.	Rebuckle belt. Check that lap belt
	does not move by pulling and
	pushing hard on infant restraint.
	If belt loosens or lengthens,
	repeat procedure.	Locking clip goes here,
		1/2 inch (1 cm) from the buckle

31