Aiwa AV-D35 manual Adjusting Speaker Level Balance, Press the Manual Select button on the remote

ADJUSTING SPEAKER LEVEL

BALANCE

3Adjust the sound level of the center and surround

speakers.

while ~,CEN~~~~[-

,.>-Vor “S-R”flashes in the display, press the UP or DOWN button on the remote control so that the sound level of the center or surround speakers matches that of the front speakers,

1

The unit is equipped with a built-in test signal generator called a noise sequencer for easy balance adjustment of all five channels. The sequencer outputs a noise signal that “travels”from channel to channel, enabling the simple adjustment of sound level to achieve the same apparent loudness, at your listening position, from each channel.

1 Select the Dolby Pro Logic mode according to your current type and placement of the speakers.

(See page 15.)

2 Press the MANUAL SELECT button on the remote

control and hold it down for about two seconds until “L’ of “L/R OdB” starts to flash.

A noise signal is sent to each channel in turn as follows:

DOLBY PRO LOGIC NORMAL or WIDE mode

+====7

+	I
CEN OdB(Center speaker)

I

L/R OdB(Right front speaker)* I

4

S-R ~dB (Right surround speaker)* 2

+

S-L OdB(Left surround speaker)* 2 I

DOILBY PRO LOGIC PHANTOM mode

~L/ROdB*i -F L/R OdW1l

i-. S-L 0dB’2~ S-R OdB*2~

3 STEREO NORMAL or WIDE mode

~L/R 0cii3= + CEN OcfB+ LIR OdB’1

1

*I l“ or “R”flashes to indicate one of the front speakers from which the noise signal is output.

*2 The noise signal is output from the L and R surround speakers at the same time.

The balance of the front speakers can be adjusted as wf?ll while “L/R”is displayed.

4Press the MANUAL SELECT button again to stop the noise signal.

When adjusting the speakers level balance of the Dolby PIro Logic, those of the DSP and 5.1 CH modes are also changed.

About the channels

The left and right speakers create the stereo effect,

The center spealker helps achieve precise sound positioning over a broad sound field.

The rear-mounted surround speakers enhance the “depth”of the sound field.

To change the surround speakers delay time of the Dolby Pro Logic mode

The surround speakers reproduce sounds a split second after the front speakers. The delay is initially set to 20 ms (milliseconds).

To change this standard delay time, press the MANUAL SELECT button on the remote control repeatedly so that “TlME20mS” is displayed. Then, press the UP or DOWN button. Each time one of the buttons is pressed, the delay time changes as shown below.

To adjust the speakers level balance while listening ito the source (Dollby Pro Logic and 5.1 CH rnoldes)

The speakers level balance can be changed after adjusting it with the noise sequencer, The balance can be changed whenever the Dolby Pro Logic system is turned on or the 5.1 CH function is selected.

1Play a disc or video software recorded in Dolby Pro Logic or Dolby Digital Surround,

2Press the MANUAL SELECT button on the n?mote control repeatedly so that “UR, “CEN”,“S-L”,“S-R”or “S-W”(lor sub woofer in 5.1 CH mode) appears on the display.

3Press the UP cwDOWN button while the speaker name to Ibe adjusted is displayed.

ENGLISH16