Graco PD223368A manual Using Latch to install Base, Belt must lay flat and not be twisted

6.4 Using LATCH to install Base

1.	For ease of installation, extend LATCH	Tongue ™
	to its maximum length.
2.	Position base in vehicle seat as
	shown.
3.	Thread LATCH through base belt
	path normally used for vehicle seat
	belt. Make sure that LATCH belt is	š
	UNDER tongue on base ™.
	Belt must lay flat and not be twisted.
4.	Hook Connectors to vehicle lower
	anchors. Pull firmly on Connectors to
	be sure they are attached š.
5.	Tighten LATCH by pushing down	›
	hard on base and pulling the
	adjustment belt ›.
6.	NEVER put two LATCH connectors on
	one vehicle LATCH anchor unless

specifically allowed by the vehicle	œ
manufacturer œ.

7. Test infant restraint for secure installation as described in infant restraint “Final Safety Check” p.38.

8.Check that the LATCH stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service.

34