Multiquip AR13HAR manual Steering Wheel Use this wheel to steer the roller

Page 15

components

Figure 4 shows the location of the components and basic components for the AR13HA compaction roller.The function of each component or control is described below:

1.Battery — Provides +12VDC to the electrical system, and is located underneath foot plate. Replace only with recommended type battery, see specification Table 1.

2.Articulating Locking Bar — Always make sure that the articulating locking bar is engaged during lifting, transport and maintenance.

3.Foot Step — To lift yourself onto the roller's platform, place foot into foot step, then grab hold of hand rail.

4.Ignition Switch — With key inserted, turn clockwise to start the engine.

5.Rear Sprinkler System — A gravity feed spray bar is provided for the wetting the roll for asphalt pavement.

6.Rear Roller — This roller is a 30 inch wide steel drum with beveled edges (no vibration). The beveled edges help prevent asphalt marring.

7.Lifting Point — Attach a crane or suitable lifting device to this point when lifting of the roller is required.

8.Rear Scrapper — This adjustable rear scrapper blade helps prevent the buildup of material between the drum and frame.

9.Fuel Tank/Fuel Gauge — The fuel capacity of the fuel tank is 9.5 gallons (36 liters). Read the gauge on top of the fuel cap to determine if fuel level is low. Fill with unleaded type gasoline.To gain access to the fuel tank, tilt the front seat forward. Fuel tank has a spill containment feature.

10.Tie-Down Transport Point — Attach a chain or suitable tie-down device to this point when transporting of the is required.

TRANSPORT

TIE-DOWN POINT

11.Front Spray Control Valve — This valve controls the flow of water to the front spray bar.Turn the water valve to the open position (counterclockwise) to let water flow, return this valve to the closed position (clockwise) when water is not required.

12.Rear Spray Control Valve — This valve controls the flow of water to the rear spray bar.Turn the water valve to the open position (counterclockwise) to let water flow,

return this valve to the closed position (clockwise) when water is not required.

13.Throttle Control — Pull all the way out to achieved maximum engine RPM's. To idle the engine, push the RED stop button inwards all the way.

14.Vibration Control Button — Press this button to activate the eccentric that will produce a vibration frequency of 4,400 vpm (vibrations per minute). Pressing the button again will stop the vibrations.

15.Shift Lever — Push the lever forward to make the roller travel in a forward direction, pull the lever backward to make the roller travel in a reverse direction. Maximum travel speed is 4.8 MPH ( 7.7 KPH). Center position is neutral, no travel.

16.Hourmeter — Indicates the number hours the unit has been in use.

17.Water Tank — Remove filler cap and fill with water. Water tank capacity is 40 gallons (181 liters). To determine if water level is low, visually inspect water level gauge (tube) at rear of roller. Add water as necessary.

18.Roll-Over Bar — This unit may be equipped with a Roll Over Protection System (ROPS option) to protect the operator when the roller is used on slopes, open trenches, sharp turns, slippery surfaces or objects in the rollers's path of travel.

19.Operator's Seat — A contoured seat that provides visibility of both front rear drum edges during operation. NEVER start the roller unless seated in the operator's seat.

20.Parking Break Lever — Pull the lever upward to set the parking break. To release the parking break, press and hold the button on top of the lever and push lever downward.

21.Seat Belt — When using the roller in working conditions always have the operator wear the seat belt. NEVER use the roller without a seat belt. If the seat belt becomes worn or damaged, have it replaced immediately.

22.Steering Wheel — Use this wheel to steer the roller.

23.Choke Knob — Used in the starting of a cold engine, or in cold weather conditions. The choke enriches the fuel mixture.

24.Hydraulic Motor — This hydraulic motor provides control for the rear of the roller

25.Documentation Box — Store and maintain Operation, Parts, and Engine manuals in this box at all times.

AR13HA/AR13HAR ROLLER (s/n 110301 & up) • operation AND PARTS manual — rev. #0 (06/22/11) — page 15

Image 15 Contents
AR13HA AR13HAR Proposition 65 warning Specifications are subject to change without notice Table of ContentsSaFeTY messages Safety InformationGeneRaL saFeTY ROLLeR saFeTY Engine saFeTYBefore servicing equipment Combustible gases FueL saFeTYBaTTeRY saFeTY eLeCTRiC sTaRT OnLY „ Use well-insulated gloves when picking up the batteryTRanspORTing saFeTY EnviROnmenTaL saFeTY„ do nOT lift machine to unnecessary heights Operating Weight w/ Drum Ballast Shipping WeightDry Weight Operating WeightDenso J16CR-U 88 in ,235 mm DimensionS Wheelbase 45.0 in ,143 mm Drum Diameter Curb Clearance Drum WidthGeneral information Power PlantTipping Rollovers Operating on SlopesRoller Components ComponentsSteering Wheel Use this wheel to steer the roller Additional Roller Components Steering Cylinder Controls direction of rollerOil Filter Spin-on type, filters oil for contaminants Basic engineInspection Before startingEngine Oil Check Hydraulic Oil Check Fuel checkWater Tank Check Battery CheckStartup OperationShift Lever Vibration ButtonSprinkler Controls Maintenance MaintenancePerform roller maintenance as indicated by and Table Hydraulic Oil System Changing Hydraulic Oil and FiltersFreewheel Engagement Valve Drum Drive Vibration and SteeringRubber Scrapper Mat Steering Pressure Test Adjust engine RPM 3,500 +/- 50 RPMForward/Reverse Hydraulic Pressure Test Vibration Circuit Pressure TestForward/Reverse Relief Valves Drive Adjustment E e r i n g R e l i e f Va lv e P r e s s u r e AdjustmentVibration Relief Valve Pressure Adjustment Drums and Main Frame Front and Rear Drum Removal and DisassemblyRemoving and Replacing Hydrostatic Pump Removing and Replacing Vibration/ Steering PumpFront Right Drum Removal Front Left Drum Removal Rear Drum Removal/Installation Vibrator Solenoid Neutral Safety SwitchBattery Alternator/RegulatorRoller Storage Preparation for long-term storageManifold test ports Relief Valve Hydraulic system diagramHydraulic hose connections ManifoldManifold Main Hydraulic Pressure Incorrect engine speed? TroubleshootingNo voltage to 12 volt solenoid? Continuity No Vibration No oil pressure?Troubleshooting engine Forward Reverse Shifter Wiring diagramPage Explanation of Code in Remarks Column CABLE, Choke SWITCH, StarterKEY, Starter Switch CABLE, ThrottleNameplate and decals Decal Powder Coated Decal Hydraulic OIL Level IndicatorDecal Engine RPM Setting Decal Steering ConsoleAR-13HA Decal MQ Logo Decal AR-13H MQ LogoDecal Danger Point Arrow UPFront drum assy RING, Retaining Housing BearingFront Roller BearingExciter assy Seal HOUSING, Bearing RightHOUSING, Bearing Left SCREW, Allen 5/16Rear Drum and Chassis assy Right Side Rear Rear DrumAllen Plug NUT, Lock 1/2Covers and Frame Articulation Lock assy Seat Rear Water Tank CoverCOVER, Steering Column WASHER, Flat 5/16Hood and rear panel assy Latch KIT, Steel SUB-WIRE Harness AssyHood Flat Washer 5/16Steering Column and Hydraulic Articulation assy CYLINDER, Steering HARNESS, WiringWASHER, Lock 5/8 Elbow FittingArticulation ARM assy ROD, Direction Stabilizer 513294ROD END 514347 Bolt 3/4 IN. x 2-1/2 EM505069 NUT 3/4 513295 513296201 202 200 206 209 204 199 196 190 192 203 191 Hydraulic drive pump assyADAPTER, Steering Pump KEY SquareAluminum Adapter PUMP, Steering184 174 172 156 119 Manifold and hydraulic OIL Filter assyOIL Filter Hydraulic Tank CAPStraight Fitting 3/4 FILTER, GASRear Fuel Tank assy Water Tank assy Elbow PVC Water TankWater Tank CAP Plug 1/2 NPT Galvanized420 Engine and Muffler assyHose Clamp HS-16 GX630RQZB2 ENGINE, Honda 20 HPMuffler Pipe Modified Tube 1.25 Flex135 136134 106 108 110 114 112 Throttle assyJoint Ball Cable Throttle AssemblyTravel Lever FWD/REV CABLE, FORWARD/REVERSEBrake control assy PIN, Clevis LEVER, BrakeBrake Link Bell CrankBattery assy CLAMP, Battery BatteryCable Battery Cable + Battery114 110 108 106 116 Scrapper assyWasher 1/2 Special SCRAPER, SupportPlate Backing NUT, Lock 1/2 NCFReigHT pOLiCY Terms and Conditions of Sale PartsPage HERE’S HOW to GET Help
Related manuals
Manual 116 pages 25.8 Kb