Multiquip AR13HAR manual Basic engine, Oil Filter Spin-on type, filters oil for contaminants

The engine (Figure 6) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturer's engine manual for operation and servicing information.

1.Oil Drain Plug — Remove to drain crankcase oil. Fill with recommended type oil as listed in Table 4.

2.Oil Filter — Spin-on type, filters oil for contaminants.

3.Spark Plug — Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean spark plug once a week.

4.Lifting Hook Eye — Attach a lifting device of adequate lifting capacity at this lifting point whenever lifting of the engine is required.

5.Fuel Filter — Prevents dirt and other debris from entering the fuel system.

6.Air Filter — Prevents dirt and other debris from entering the fuel system. Unsnap air filter cover to gain access to filter element.

7.Oil Filler Cap — Remove to add engine oil.

8.Oil Dip Stick — Remove to check amount and condition of oil in crankcase. Refill or replace with recommended type oil as listed in Table 4.

9.Starter — Starts engine when ignition key is rotated to the "ON" position.