Multiquip AR13HAR manual Battery Check, Water Tank Check

3.If the hydraulic oil level is low, remove the hydraulic oil cap (Figure 14) and fill with type ISO 46 anti-wear type hydraulic oil to the recommended operating level.

Battery Check

A 12-volt DC battery (Figure 16) is shipped dry, and will require a proper electrolyte level for operation.

ALWAYS be sure that the battery cables are properly connected to the battery terminals as shown below. Generally the RED cable will be connected to the positive terminal of the battery, and the BLACK cable will be connected to the negative terminal of the battery.

Figure 14. Hydraulic Oil Reservoir Filler Port

Water Tank Check

1.To check the water tank water level, place the roller on secure level ground.

2.The amount of water inside the water tank can be visually inspected by reading the water tube (Figure 15) that runs vertically along the water tank at the rear of the roller. This tube indicates the amount of water inside the water tank. Total tank capacity is 40 gallons (181 liters.)

WATER

TANK

CAP

WATER

TANK

WATER

LEVEL

Figure 16. Battery

NOTICE

If the battery cables are connected incorrectly, electrical damage will occur causing damage to the roller's electrical circuits. Pay close attention to the polarity of the battery when connecting the battery.

REAR

TUBE