Multiquip AR13HAR manual Fuel check, Hydraulic Oil Check

fuel check

DANGER

Motor fuels are highly flammable and can be dangerous if mishandled. DO NOT smoke while refueling. DO NOT attempt to refuel the pump if the engine is hot or running.

1.To check the engine fuel level, place the roller on secure level ground with the engine stopped.

2.Tilt the operator's seat (Figure 10) forward to gain access to the fuel tank.

Figure 10. Fuel Tank Access

3.Read the fuel gauge (Figure 11) located on top of the fuel tank to determine if fuel level is low.

Figure 11. Fuel Gauge

4.If the fuel level is low, remove the fuel filler cap/gauge and fill with unleaded gasoline. Wipe up any spilled fuel immediately.

5.Pay attention to the fuel tank capacity when replenishing fuel (Figure 12). Refer to the fuel tank capacity listed on the specifications table.

Figure 12. Adding Fuel

6.After replenishing fuel, make sure fuel cap is securely tighten to fuel tank. Return operator's seat to normal operating position.

Hydraulic Oil Check

1.To check the hydraulic oil level, place the roller on secure level ground with the engine stopped.

2.Visually inspect the hydraulic oil sight glass (Figure

13)located on the right rear of the front drum. For normal operation the hydraulic oil level must be below the top and above the bottom of the sight glass. DO NOT OVERFILL!

Figure 13. Hydraulic Oil Sightglass