Multiquip AR13HAR manual ROLLeR saFeTY, Engine saFeTY, Before servicing equipment

Page 6
DANGEROUS
GAS FUMES

Safety Information

ROLLeR saFeTY

DangeR

„neveR operate the equipment in an explosive atmosphere or near combustible materials.An explosion or fi re could result causing severe bodily harm or even death.

WaRning

„neveR disconnect any emergency or safety devices. These devices are intended for operator safety. Disconnection of these devices can cause severe injury, bodily harm or even death. Disconnection of any of these devices will void all warranties.

CauTiOn

„neveR lubricate components or attempt service on a running machine.

„Never leave the roller unattended with the engine running. Turn off engine.

„Use chock blocks when parking roller on a grade.

„Use extreme care when operating near obstructions, on slippery surfaces, grades, and slide slopes.

„When reversing, particularly on the edges and banks of ditches, as well as in front of obstaces, the operator must stay in a standing position at a safe distance from the machine.

„When operating near any house/building or pipelines, always check the effect of machine vibration. Stop work if necessary.

„DO nOT operate the roller with the covers open.

„aLWaYs keep the machine away from other personnel and obstacles. Always keep immediate are free of bystanders.

NOTICE

„aLWaYs keep the machine in proper running condition.

„Fix damage to machine and replace any broken parts immediately.

„DO nOT use worn-out hoses or couplings. Inspect daily.

„aLWaYs store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children and unauthorized personnel.

engine saFeTY

DangeR

„The engine fuel exhaust gases contain poisonous carbon monoxide. This gas is colorless and odorless, and can cause death if inhaled.

„The engine of this equipment requires an adequate free fl ow of cooling air. neveR operate this equipment

in any enclosed or narrow area where free fl ow of the air is restricted. If the air fl ow is restricted it will cause injury to people and property and serious damage to the equipment or engine.

WaRning

„DO nOT place hands or fingers inside engine compartment when engine is running.

„neveR operate the engine with heat shields or guards removed.

„ Keep fi ngers, hands hair and clothing away from all moving parts to prevent injury.

„DO nOT remove the engine oil drain plug

while the engine is hot. Hot oil will gush out of the oil tank and severely scald any persons in the general area of the roller.

CauTiOn

„neveR touch the hot exhaust manifold, muffl er or cylinder. Allow these parts to cool

before servicing equipment.

„Always turn the engine off before performing maintenance.

page 6 — AR13HA/AR13HAR ROLLER (s/n 110301 & up) • operation AND PARTS manual — rev. #0 (06/22/11)

Image 6 Contents
AR13HA AR13HAR Proposition 65 warning Table of Contents Specifications are subject to change without noticeSafety Information SaFeTY messagesGeneRaL saFeTY ROLLeR saFeTY Engine saFeTYBefore servicing equipment „ Use well-insulated gloves when picking up the battery FueL saFeTYBaTTeRY saFeTY eLeCTRiC sTaRT OnLY Combustible gasesTRanspORTing saFeTY EnviROnmenTaL saFeTY„ do nOT lift machine to unnecessary heights Operating Weight Shipping WeightDry Weight Operating Weight w/ Drum BallastDenso J16CR-U Drum Width DimensionSWheelbase 45.0 in ,143 mm Drum Diameter Curb Clearance 88 in ,235 mmPower Plant General informationOperating on Slopes Tipping RolloversComponents Roller ComponentsSteering Wheel Use this wheel to steer the roller Steering Cylinder Controls direction of roller Additional Roller ComponentsBasic engine Oil Filter Spin-on type, filters oil for contaminantsInspection Before startingEngine Oil Check Fuel check Hydraulic Oil CheckBattery Check Water Tank CheckOperation StartupShift Lever Vibration ButtonSprinkler Controls Maintenance MaintenancePerform roller maintenance as indicated by and Table Hydraulic Oil System Changing Hydraulic Oil and FiltersFreewheel Engagement Valve Drum Drive Vibration and SteeringRubber Scrapper Mat Vibration Circuit Pressure Test Adjust engine RPM 3,500 +/- 50 RPMForward/Reverse Hydraulic Pressure Test Steering Pressure TestForward/Reverse Relief Valves Drive Adjustment E e r i n g R e l i e f Va lv e P r e s s u r e AdjustmentVibration Relief Valve Pressure Adjustment Removing and Replacing Vibration/ Steering Pump Front and Rear Drum Removal and DisassemblyRemoving and Replacing Hydrostatic Pump Drums and Main FrameFront Right Drum Removal Front Left Drum Removal Rear Drum Removal/Installation Alternator/Regulator Neutral Safety SwitchBattery Vibrator SolenoidPreparation for long-term storage Roller StorageManifold test ports Hydraulic system diagram Relief ValveManifold Hydraulic hose connectionsManifold Continuity No Vibration No oil pressure? TroubleshootingNo voltage to 12 volt solenoid? Main Hydraulic Pressure Incorrect engine speed?Troubleshooting engine Wiring diagram Forward Reverse ShifterPage Explanation of Code in Remarks Column CABLE, Throttle SWITCH, StarterKEY, Starter Switch CABLE, ChokeNameplate and decals Decal Steering Console Decal Hydraulic OIL Level IndicatorDecal Engine RPM Setting Decal Powder CoatedAR-13HA Point Arrow UP Decal AR-13H MQ LogoDecal Danger Decal MQ LogoFront drum assy Bearing Housing BearingFront Roller RING, RetainingExciter assy SCREW, Allen 5/16 HOUSING, Bearing RightHOUSING, Bearing Left SealRear Drum and Chassis assy NUT, Lock 1/2 Rear DrumAllen Plug Right Side RearCovers and Frame Articulation Lock assy WASHER, Flat 5/16 Rear Water Tank CoverCOVER, Steering Column SeatHood and rear panel assy Flat Washer 5/16 SUB-WIRE Harness AssyHood Latch KIT, SteelSteering Column and Hydraulic Articulation assy Elbow Fitting HARNESS, WiringWASHER, Lock 5/8 CYLINDER, SteeringArticulation ARM assy 514347 Bolt 3/4 IN. x 2-1/2 EM505069 NUT 3/4 513295 513296 513294ROD END ROD, Direction StabilizerHydraulic drive pump assy 201 202 200 206 209 204 199 196 190 192 203 191PUMP, Steering KEY SquareAluminum Adapter ADAPTER, Steering PumpManifold and hydraulic OIL Filter assy 184 174 172 156 119FILTER, GAS Hydraulic Tank CAPStraight Fitting 3/4 OIL FilterRear Fuel Tank assy Water Tank assy Plug 1/2 NPT Galvanized Water TankWater Tank CAP Elbow PVCEngine and Muffler assy 420Tube 1.25 Flex GX630RQZB2 ENGINE, Honda 20 HPMuffler Pipe Modified Hose Clamp HS-16Throttle assy 135 136134 106 108 110 114 112CABLE, FORWARD/REVERSE Cable Throttle AssemblyTravel Lever FWD/REV Joint BallBrake control assy Bell Crank LEVER, BrakeBrake Link PIN, ClevisBattery assy Cable + Battery BatteryCable Battery CLAMP, BatteryScrapper assy 114 110 108 106 116NUT, Lock 1/2 NC SCRAPER, SupportPlate Backing Washer 1/2 SpecialTerms and Conditions of Sale Parts FReigHT pOLiCYPage HERE’S HOW to GET Help
Related manuals
Manual 116 pages 25.8 Kb