Chicco Car Seat Harness Buckle, Chest Clip, Harness Adjuster To loosen harness, firmly press

Page 10

CARRIER HARNESS FEATURES

Harness Buckle

To release buckle tongues, firmly press red button on buckle. To fasten, insert each tongue into buckle, listen for a click and then tug to verify that it is latched.

Check that buckle functions properly and is kept free of dirt. For cleaning instructions, see page 40.

Chest Clip

 

To separate chest clip, push center

 

button and pull apart.To fasten, push

 

together until locked.

a

Position chest clip at center of child’s chest, level with armpits.

Harness Adjuster

aTo loosen harness, firmly press

button while pulling out on both

b

shoulder straps.

 

b To tighten harness, slowly pull

 

adjuster strap until harness is snug

 

around child.

 

Keep adjuster area clean and free of dirt. DO NOT attempt to remove adjuster cover or button.

HANDLE

Handle has 3 LOCKED positions.

To rotate to a new position, press both buttons near pivot.

 

 

 

BE SURE handle is

 

 

 

 

 

 

LOCKED in “CARRY” position

Carry

 

before lifting carrier by

 

 

handle. An unlocked handle

 

 

could move unexpectedly,

 

 

causing injury to child.

 

 

 

 

ALWAYS place handle in

 

 

 

 

one of the LOCKED positions

Store

when using Child Restraint in

 

vehicle.

 

Stand

NEVER hang toys or other objects from handle when using child restraint in vehicle. They could seriously injure a child in a sudden stop or crash.

18

19

Image 10
Contents Page Table of Contents Ensure Child is in Size Range Safe USE ChecklistRegistration & Recall TakeTime to ReadThis User Guide Install Restraint Correctly Never install in rear facing or side facing vehicle seatsCheck Condition of Restraint Base Overview Base FeaturesStorage Compartment Bubble is between arrowsPull Latch Pull Strap to Removing LatchStoring Latch Firmly slide shoulder beltCarrier Overview Harness Buckle Harness Adjuster To loosen harness, firmly pressChest Clip To Install Insert in Carrier To extend/retract visorHead Support To release carrier from baseCarrier out of base CARRIER/BASE AttachmentOnly use this child restraint Child RequirementsPounds 2 and 5 kg Make sure child is properly secured Securing Child in CarrierProperly secured and tightened Harness around your child Safety Tips for Securing ChildSecure Child Checklist Check Position of Chest ClipNon-Locking ELR Lap Belts Results in Secure Installation of RestraintUnsafe Vehicle Belts Best Position is one thatBubble Must be Between arrows Check Installation Belts Must be TightUninstalling Base Carrier to BaseInto vehicle seat Check Installation Latch belts Must beInstallation Using Latch Not interfere with Attachment of Carrier To BaseVehicle belt Must be Tight Check InstallationInstallation Using Latch Installation Without Base SecureInstallation in Aircraft Installing the Seat PadCleaning & Maintenance Cleaning Harness Latch Straps Cleaning PlasticsCleaning Buckle Latch Hardware