Chicco Car Seat manual Check Installation, Vehicle belt Must be Tight, Secure

INSTALLATION USING LATCH

INSTALLATION WITHOUT BASE

Uninstalling Base

Remove Carrier from Base

1Loosen LATCH by lifting the LATCH Release Lever and pulling Base away from vehicle seat back.

2Detach LATCH Connectors

by pressing the red button on each LATCH Connector, and remove Base from vehicle.

Storing LATCH

Insert LATCH Connectors into storage pockets. a

1

2

1

1Position Carrier rear facing on vehicle seat, with child properly secured in Carrier.

2Route Vehicle Belt under both Belt Guides, and buckle the vehicle belt.

3Tighten Vehicle Belt while pushing Carrier firmly into vehicle seat.

A tightly rolled towel may be used under the front edge of the Carrier if needed for stable, secure installation.

2

3 4

b

1Pull LATCH Pull Strap to secure LATCH Connectors.

2Roll LATCH Pull Strap and store in Pull Strap Storage Pocket.

aa

2

4 Check Installation:

a Level Line on Carrier MUST be LEVEL with ground.

bVehicle belt MUST be TIGHT.

c Carrier MUST be STABLE	a
and secure.

NEVER travel with CHILD RESTRAINT unsecured in vehicle. Passengers may be injured during a sudden stop or crash. When not using LATCH, the LATCH Connectors and Pull Strap MUST be stored properly.

NEVER install CARRIER without Base using a non-locking ELR vehicle belt. The installation will NOT be secure. Refer to your vehicle owner’s manual for detailed vehicle belt information.

36 37