Chicco Car Seat manual Removing Latch, Storing Latch, Pull Latch Pull Strap to

Page 8

LATCH REMOVAL & STORAGE

This Child Restraint can be safely installed using vehicle belts or LATCH. LATCH is a Child Restraint attachment system that is standard in most vehicles manufactured after September 1, 2002. Refer to your vehicle owner’s manual for details regarding LATCH use in your vehicle.

Removing LATCH:

1

1 Pull LATCH Connectors out of

 

storage pockets while lifting up on

 

LATCH Release Lever.

 

Storing LATCH:

2

2 Insert LATCH Connectors into

 

storage pockets.

3Pull LATCH Pull Strap to

secure LATCH Connectors.

3

4 Roll LATCH Pull Strap and store in Pull Strap Storage Pocket.

4

When not using LATCH, the LATCH Connectors and Pull Strap MUST be stored properly to allow Carrier to attach securely to Base.

SHOULDER BELT LOCKOFF

The Shoulder Belt Lockoff is used when installing the Base using your vehicle belts. It locks the vehicle shoulder belt in place, ensuring a stable, secure Base installation.

1 Do not put the shoulder belt

1

in the locked mode.

2 With vehicle belt tight, position the shoulder belt under the Shoulder Belt Lockoff that is on the opposite side of the buckle.

3Firmly slide shoulder belt

under the lockoff. (Optional: Once

2

3

the base is installed tightly, the

 

 

shoulder belt can be put in the locked mode. See vehicle owner’s manual or label on seat belt for more information.)

Refer to “Installation Using Vehicle Belt” on page 32 for detailed installation instructions.

14

15

Image 8
Contents Page Table of Contents Registration & Recall Safe USE ChecklistEnsure Child is in Size Range TakeTime to ReadThis User Guide Install Restraint Correctly Never install in rear facing or side facing vehicle seatsCheck Condition of Restraint Base Features Storage CompartmentBase Overview Bubble is between arrowsRemoving Latch Storing LatchPull Latch Pull Strap to Firmly slide shoulder beltCarrier Overview Chest Clip Harness Adjuster To loosen harness, firmly pressHarness Buckle To Install Insert in Carrier To extend/retract visorTo release carrier from base Carrier out of baseHead Support CARRIER/BASE AttachmentPounds 2 and 5 kg Child RequirementsOnly use this child restraint Make sure child is properly secured Securing Child in CarrierSafety Tips for Securing Child Secure Child ChecklistProperly secured and tightened Harness around your child Check Position of Chest ClipResults in Secure Installation of Restraint Unsafe Vehicle BeltsNon-Locking ELR Lap Belts Best Position is one thatCheck Installation Belts Must be Tight Uninstalling BaseBubble Must be Between arrows Carrier to BaseCheck Installation Latch belts Must be Installation Using LatchInto vehicle seat Not interfere with Attachment of Carrier To BaseCheck Installation Installation Using Latch Installation Without BaseVehicle belt Must be Tight SecureCleaning & Maintenance Installing the Seat PadInstallation in Aircraft Cleaning Buckle Latch Hardware Cleaning PlasticsCleaning Harness Latch Straps