Chicco Car Seat manual Child Requirements, Only use this child restraint, Pounds 2 and 5 kg

Page 13

CHILD REQUIREMENTS

Child Requirements

Children should ride in a REAR-FACING Child Restraint until they’re at least 1 year old AND weigh at least 20 lbs.

The Chicco KeyFit 30 Child Restraint can be used rear-facing up to 30 lbs.

1 ONLY use this child restraint 1

if the child meets all of the following requirements:

Weight between 4 and 30 pounds (2 and 13.5 kg).

Height is less than 30 inches (76 cm).

Top of head is at least 1 inch below top of carrier.

2 Use Newborn Insert for infants

2

 

who weigh between 4 and 11

 

pounds (2 and 5 kg).

 

For premature infants, you must consult the infant’s doctor before using this Child Restraint. A premature infant may have difficulty breathing or have other medical problems when placed in a seated position.

CHANGING HARNESS HEIGHT

1 With child firmly seated in

1

carrier, identify correct slots for harness. Select closest slots AT or BELOW child’s shoulders.

2 With child removed and harness

2

loosened, turn carrier over to

 

expose splitter. Unhook one strap

 

from splitter.

 

3 Pull end of loose strap out of

3

pad and return it back through

 

correct slot. Do not twist strap.

 

4 Re-attach strap to splitter. Connection to splitter should look like illustration.

5Repeat for other strap. Straps

must be free of twists and securely 4 fastened to splitter.

6Check that Harness is secure

and working properly.

NEVER remove Harness or harness components from Carrier. DO NOT USE Child Restraint if any part of harness is damaged. Call 1-877-424-4226 to order a replacement harness.

24

25

Image 13
Contents Page Table of Contents Ensure Child is in Size Range Safe USE ChecklistRegistration & Recall TakeTime to ReadThis User Guide Never install in rear facing or side facing vehicle seats Install Restraint CorrectlyCheck Condition of Restraint Storage Compartment Base FeaturesBase Overview Bubble is between arrowsStoring Latch Removing LatchPull Latch Pull Strap to Firmly slide shoulder beltCarrier Overview Harness Buckle Harness Adjuster To loosen harness, firmly press Chest Clip To extend/retract visor To Install Insert in CarrierCarrier out of base To release carrier from baseHead Support CARRIER/BASE AttachmentOnly use this child restraint Child RequirementsPounds 2 and 5 kg Securing Child in Carrier Make sure child is properly securedSecure Child Checklist Safety Tips for Securing ChildProperly secured and tightened Harness around your child Check Position of Chest ClipUnsafe Vehicle Belts Results in Secure Installation of RestraintNon-Locking ELR Lap Belts Best Position is one thatUninstalling Base Check Installation Belts Must be TightBubble Must be Between arrows Carrier to BaseInstallation Using Latch Check Installation Latch belts Must beInto vehicle seat Not interfere with Attachment of Carrier To BaseInstallation Using Latch Installation Without Base Check InstallationVehicle belt Must be Tight SecureInstallation in Aircraft Installing the Seat PadCleaning & Maintenance Cleaning Harness Latch Straps Cleaning PlasticsCleaning Buckle Latch Hardware