Chicco Car Seat manual To Install Insert in Carrier, To extend/retract visor

Page 11

CANOPY

 

To Adjust Canopy, grab bow on both

a

sides and rotate. Detach fastener tabs

 

when rotating toward front of carrier.

 

a To Remove Canopy Fabric, pull

 

fabric away from Canopy Mount to

 

expose button. Press button on canopy

 

mount to release end of bow. Slide

 

canopy fabric off bow and detach

 

canopy from rear of pad.

 

Release bow from canopy

b

mount on opposite side of carrier

 

if using carrier without canopy.

 

To replace canopy, reverse previous

 

steps.

 

NEWBORN INSERT

Use Newborn Insert to provide additional support and ensure

a secure harness fit for smaller 1 infants.

The harness height may have to be changed to fit your child. Before using insert, read the instructions on “Changing Harness Height” and “Securing Child in Carrier”

2

To Install Insert in Carrier

1 Pull End of Buckle through center slot in insert.

2 Pull Both Harness Straps over and around side panels. Push

To extend/retract visor

 

b To retract the visor, gently push it

 

downward and allow it to pop up under

 

the canopy. The canopy must be

c

extended before attempting to retract

 

the visor.

 

c To extend the visor, gently pull

 

it downward from underneath the

 

canopy and allow it to pop up in its

 

extended position.

 

insert firmly into bottom of carrier.

Top of insert should always be BELOW the lower harness slots.

3 When properly installed, the Newborn Insert and harness should look like drawing.

3

ONLY USE Insert with infants who weigh between 4 and 11 lbs. NEVER USE Insert if child weighs more than 11 lbs!

20

21

Image 11
Contents Page Table of Contents Registration & Recall Safe USE ChecklistEnsure Child is in Size Range TakeTime to ReadThis User Guide Never install in rear facing or side facing vehicle seats Install Restraint CorrectlyCheck Condition of Restraint Bubble is between arrows Base FeaturesStorage Compartment Base OverviewFirmly slide shoulder belt Removing LatchStoring Latch Pull Latch Pull Strap toCarrier Overview Chest Clip Harness Adjuster To loosen harness, firmly pressHarness Buckle To extend/retract visor To Install Insert in CarrierCARRIER/BASE Attachment To release carrier from baseCarrier out of base Head SupportPounds 2 and 5 kg Child RequirementsOnly use this child restraint Securing Child in Carrier Make sure child is properly securedCheck Position of Chest Clip Safety Tips for Securing ChildSecure Child Checklist Properly secured and tightened Harness around your childBest Position is one that Results in Secure Installation of RestraintUnsafe Vehicle Belts Non-Locking ELR Lap BeltsCarrier to Base Check Installation Belts Must be TightUninstalling Base Bubble Must be Between arrowsNot interfere with Attachment of Carrier To Base Check Installation Latch belts Must beInstallation Using Latch Into vehicle seatSecure Check InstallationInstallation Using Latch Installation Without Base Vehicle belt Must be TightCleaning & Maintenance Installing the Seat PadInstallation in Aircraft Cleaning Buckle Latch Hardware Cleaning PlasticsCleaning Harness Latch Straps