Chicco Car Seat Cleaning Plastics, Cleaning Harness Latch Straps, Cleaning Buckle Latch Hardware

Page 21

CLEANING & MAINTENANCE

NEVER remove Harness or harness components from Carrier. If harness is extremely soiled or damaged, Call Chicco to order a replacement.

Cleaning Plastics

Sponge clean using warm water and mild soap.Towel dry.

DO NOT USE BLEACH, solvents, or household cleaners, as they may weaken the plastics.

Cleaning Harness

and LATCH Straps

Sponge clean using warm water and mild soap. Air dry.

DO NOT USE BLEACH, solvents, or household cleaners, as they may weaken the straps.

Replacement Parts Many replacement parts are available for your Child Restraint. To order replacement parts, call:

Chicco Customer Service 1-877-424-4226

Please have the Restraint model and serial numbers available to expedite service.

Cleaning Buckle

and LATCH Hardware

Sponge clean, or rinse in cup of warm water.

DO NOT USE ANY SOAPS OR LUBRICANTS on Buckle or LATCH Hardware. It may cause them to malfunction.

40

Page 20 Page 21
Image 21
Page 20 Page 21
Contents Page Table of Contents Safe USE Checklist Ensure Child is in Size RangeRegistration & Recall TakeTime to ReadThis User Guide Never install in rear facing or side facing vehicle seats Install Restraint CorrectlyCheck Condition of Restraint Storage Compartment Base FeaturesBase Overview Bubble is between arrowsStoring Latch Removing LatchPull Latch Pull Strap to Firmly slide shoulder beltCarrier Overview Harness Adjuster To loosen harness, firmly press Harness BuckleChest Clip To extend/retract visor To Install Insert in CarrierCarrier out of base To release carrier from baseHead Support CARRIER/BASE AttachmentChild Requirements Only use this child restraintPounds 2 and 5 kg Securing Child in Carrier Make sure child is properly securedSecure Child Checklist Safety Tips for Securing ChildProperly secured and tightened Harness around your child Check Position of Chest ClipUnsafe Vehicle Belts Results in Secure Installation of RestraintNon-Locking ELR Lap Belts Best Position is one thatUninstalling Base Check Installation Belts Must be TightBubble Must be Between arrows Carrier to BaseInstallation Using Latch Check Installation Latch belts Must beInto vehicle seat Not interfere with Attachment of Carrier To BaseInstallation Using Latch Installation Without Base Check InstallationVehicle belt Must be Tight SecureInstalling the Seat Pad Installation in AircraftCleaning & Maintenance Cleaning Plastics Cleaning Harness Latch StrapsCleaning Buckle Latch Hardware
Top Page Image Contents