Chicco Car Seat manual Check Installation Belts Must be Tight, Bubble Must be Between arrows

Page 17

INSTALLATION USING VEHICLE BELT

LATCH or Vehicle Belt? This Child Restraint can be safely installed using Vehicle Belts or LATCH. Use the method that results in the MOST SECURE installation in your vehicle.

INSTALLATION USING VEHICLE BELT

If using Vehicle Lap Belt only

(no Shoulder Belt), make sure

that Lap Belt is LOCKED, and

that free end of Lap Belt is

neatly stored so it DOES NOT

1Position Base in forward facing vehicle seat with Recline Foot against seat back.

2Adjust Base Angle by pushing Recline Buttons while lifting Base. Angle is correct when Bubble is between arrows.

Vehicle must be on a level surface for the Bubble to indicate correctly.

3Route Vehicle Belt through openings in Base and buckle the vehicle belt. (Do not put the shoulder belt in locked mode.)

4Tighten Vehicle Belt while pushing Base firmly into vehicle seat.

5 Secure Vehicle Shoulder Belt firmly under Shoulder Belt Lockoff, while keeping tension on Belt. Only use the lockoff on the opposite side of the buckle.

1

2

3

4

5

 

INTERFERE with attachment

 

 

of Carrier to Base.

 

6

CHECK Installation:

 

 

a Belts MUST be TIGHT.

 

 

b Base MUST be STABLE.

 

 

c Bubble MUST be

 

 

between arrows.

6

 

d Belts & Buckles MUST NOT

 

 

 

INTERFERE with attachment

 

 

of Carrier to Base.

 

7

Attach CarrierTo Base after

 

properly securing child in Carrier.

 

ALWAYS lift up on Carrier to verify it is properly attached to the Base.

Uninstalling Base:

7

 

Remove Carrier from Base,

 

unbuckle Vehicle Belt, and remove

 

Base from vehicle.

 

NEVER travel with Child Restraint unsecured in vehicle. Passengers may be injured during a sudden stop or crash.

32

33

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Page Table of Contents Registration & Recall Safe USE ChecklistEnsure Child is in Size Range TakeTime to ReadThis User Guide Never install in rear facing or side facing vehicle seats Install Restraint CorrectlyCheck Condition of Restraint Storage Compartment Base FeaturesBase Overview Bubble is between arrowsStoring Latch Removing LatchPull Latch Pull Strap to Firmly slide shoulder beltCarrier Overview Chest Clip Harness Adjuster To loosen harness, firmly pressHarness Buckle To extend/retract visor To Install Insert in CarrierCarrier out of base To release carrier from baseHead Support CARRIER/BASE AttachmentPounds 2 and 5 kg Child RequirementsOnly use this child restraint Securing Child in Carrier Make sure child is properly securedSecure Child Checklist Safety Tips for Securing ChildProperly secured and tightened Harness around your child Check Position of Chest ClipUnsafe Vehicle Belts Results in Secure Installation of RestraintNon-Locking ELR Lap Belts Best Position is one thatUninstalling Base Check Installation Belts Must be TightBubble Must be Between arrows Carrier to BaseInstallation Using Latch Check Installation Latch belts Must beInto vehicle seat Not interfere with Attachment of Carrier To BaseInstallation Using Latch Installation Without Base Check InstallationVehicle belt Must be Tight SecureCleaning & Maintenance Installing the Seat PadInstallation in Aircraft Cleaning Buckle Latch Hardware Cleaning PlasticsCleaning Harness Latch Straps
Top Page Image Contents