Locking Clip
NOTE: The locking clip is located on the back of the seat. You do not need a locking clip when using this seat as a
Remove the locking clip when the vehicle seat belt is not being used with the child restraint. A locking clip will not fix all types of seat belt problems.
Before you put your child restraint in the vehicle, buckle the lap/shoulder belt. Pull on the lap belt portion. If it loosens or slips, you must either use a locking clip to hold the seat belt tight or move the child restraint to another seating location.
4 |
Position locking clip about 1 in. (2.5 cm) from vehicle belt’s buckle plate.
1 |
Thread both vehicle lap and shoulder belts through the slot (as shown) and out other side. Buckle. Pull up on shoulder belt until all slack is out and lap belt is tight.
2 | Grasp both vehicle belts | |
together just behind the | ||
| ||
| buckle plate and unbuckle. |
NOTE: If the buckle plate ends up behind the child restraint, grasp the belts to the outside of the child restraint, as close to the buckle plate as possible.
3 | Thread both portions of |
the vehicle belt onto the | |
| locking clip. |
22
4 | Rebuckle belt. Lap belt |
| portion should now be |
| tight. If not, remove |
| locking clip and repeat all |
| steps. |
23