Eddie Bauer 22859 manual To change harness location, Check Harness Height

Page 8

5

Place the child’s bottom and back flat against the child restraint.This will increase comfort and allow the harness to properly tighten.

8

To change harness location:

From the back of the seat, remove harness from splitter plate.

6

Harness

Guide

7

Check Harness Height

Forward-Facing Position: Harness guide must be even with or just above the shoulders.

If the top harness guides are below the child’s shoulders, the child weighs at least 40 lbs. (18.1 kg) and is over 1 year old, convert the seat to a belt-positioning booster.

Determine which set of harness guide slots works best for your child. Adjust if needed.

Pull harness through the

9harness guides from the front.

Rethread harness into new harness guide location. Refasten harness to splitter plate. Make sure harness does not twist.

!WARNING

Failure to reattach the harness correctly can result in serious injury or death.

12

13

Image 8
Contents Commuter/Ventura/ High Back Booster Table of Contents Before You BeginPage Registration and Recall Information Aircraft InstallationWarm Weather Use Seat Buckles Air Bag Seat Bight Where seat cushions meet Understanding Your VehicleAnchor Bracket Latch AnchorsChild Restraint Parts Buckle Plates Top Anchorage Tether Strap & Hook InstructionsLbs .1-36.3 kg 43-52 in .1-132.1 cm and Over 1Year Old Choosing Restraint and PositionPreparing Child Restraint to Fit Your Child To change harness location Check Harness HeightStrap to tighten harness SnuglyPosition harness straps over the child’s shoulders Snap the harness retainer togetherChild’s neck TogetherPosition the harness Child Press on release button and pull apartDown on the harness Vehicle belt too short Knowing Your Vehicle BeltsManual Belts Locking Clip Year of age Forward-Facing Use Forward-Facing InstallationForward Forward-Facing Installation with Vehicle Belts After checking for hotYour child in the child Child RestraintAge Against the backVehicle seat forward To Attach Top Anchorage Strap Adjusting the Top Anchorage StrapStorage of Top Anchorage Strap Belt-Positioning Booster Use HookPull harness out of shell Removal of HarnessSlots from the front Belt-Positioning Booster Installation Reinstall Harness Stops against the shellRemoving Seat Pad for Cleaning Trouble Shooting Installation TipsWarranty Replacement Parts Order Form