Eddie Bauer 22859 manual Removing Seat Pad for Cleaning, Section

Page 22

Removing Seat Pad for Cleaning

1

Remove harness as

described in the “Belt-

 

Positioning Booster”

 

section.

If your child restraint has armrests, pull armrest covers off armrests and pull through hole in back of shell.

3

Remove the 6 harness guides (shown in red) by pushing down on one edge with one hand and pulling out from the front side with the other.

2

From underneath bottom of shell, release the elastic straps shown in red.

4

Pull pad off shell.

 

Clean with warm sudsy water, rinse clean and air dry. Do not use bleach or other harsh cleaners.

Replace seat pad by reversing order; lay pad on shell, replace all harness guides, turn shell over to expose the back, rehook elastic straps, and replace armrest covers. Rethread harness (see belt-positioning booster section).

40

41

Image 22
Contents Commuter/Ventura/ High Back Booster Table of Contents Before You BeginPage Warm Weather Use Aircraft InstallationRegistration and Recall Information Anchor Bracket Seat Buckles Air Bag Seat Bight Where seat cushions meetUnderstanding Your Vehicle Latch AnchorsChild Restraint Parts Buckle Plates Top Anchorage Tether Strap & Hook InstructionsPreparing Child Restraint to Fit Your Child Choosing Restraint and PositionLbs .1-36.3 kg 43-52 in .1-132.1 cm and Over 1Year Old To change harness location Check Harness HeightPosition harness straps over the child’s shoulders Strap to tighten harnessSnugly Snap the harness retainer togetherPosition the harness TogetherChild’s neck Down on the harness Press on release button and pull apartChild Manual Belts Knowing Your Vehicle BeltsVehicle belt too short Locking Clip Forward Forward-Facing Use Forward-Facing InstallationYear of age Your child in the child Forward-Facing Installation with Vehicle BeltsAfter checking for hot Child RestraintVehicle seat forward Against the backAge Storage of Top Anchorage Strap Adjusting the Top Anchorage StrapTo Attach Top Anchorage Strap Belt-Positioning Booster Use HookSlots from the front Removal of HarnessPull harness out of shell Belt-Positioning Booster Installation Reinstall Harness Stops against the shellRemoving Seat Pad for Cleaning Trouble Shooting Installation TipsWarranty Replacement Parts Order Form