Eddie Bauer 22859 manual Belt-Positioning Booster Use, Hook

Page 18

1 Left side

Right side

Hook

 

To child restraint

2

 

3

4

5

To AttachTop Anchorage Strap: At the adjuster, unlace free end of strap from right side of adjuster slide and loosen into “loops” (1). Put knee in child restriant and push down; attach hook to anchor to estimate how much you need, then unhook

(2).

To loosen top anchorage strap: With adjuster in hand, pull the top strap (3) between adjuster and child restriant to desired length. Attach hook to anchor, check fit, repeat steps if necessary. You must rethread the free end of strap back down through the right slot (5) or the tether will not hold. Tighten strap so “loops” are gone and there is no slack or play.

To tighten tether: With adjuster in hand, pull the top strap (4) between adjuster and hook to the desired length. Attach hook to anchor, check fit, repeat steps if necessary. You must rethread the free end of strap back down through the right slot (5) or the tether will not hold. Tighten strap so “loops” are gone and there is no slack or play.

Belt-Positioning Booster Use

Refer to the “Choosing Restraint and Position” sectionto make sure your child is at the proper weight and height to use the belt- positioning booster.

Lap/Shoulder Belt

Do not use LATCH or tether strap when using the Belt-Positioning Booster.

You MUST fasten the LATCH belt hooks together behind seat.

When your child is over 40 lbs. (18.1 kg) or 43” (110.1 cm) and over 1 year old, you must remove the harness and use this child restraint as a belt- positioning booster.

!WARNING

Belt-Positioning Booster Use: 40-80 lbs. (18.1-36.3 kg), 43-52” (110.1-132.1 cm), Over 1 year of

!WARNING

You must follow the threading diagram exactly. Failure to follow these steps could cause the strap to loosen in a crash, which can result in serious injury or death.

Loose LATCH hooks can result in serious injury or death.

age.

32

33

Image 18
Contents Commuter/Ventura/ High Back Booster Table of Contents Before You BeginPage Aircraft Installation Warm Weather UseRegistration and Recall Information Anchor Bracket Seat Buckles Air Bag Seat Bight Where seat cushions meetUnderstanding Your Vehicle Latch AnchorsChild Restraint Parts Buckle Plates Top Anchorage Tether Strap & Hook InstructionsChoosing Restraint and Position Preparing Child Restraint to Fit Your ChildLbs .1-36.3 kg 43-52 in .1-132.1 cm and Over 1Year Old To change harness location Check Harness HeightPosition harness straps over the child’s shoulders Strap to tighten harnessSnugly Snap the harness retainer togetherTogether Position the harnessChild’s neck Press on release button and pull apart Down on the harnessChild Knowing Your Vehicle Belts Manual BeltsVehicle belt too short Locking Clip Forward-Facing Use Forward-Facing Installation ForwardYear of age Your child in the child Forward-Facing Installation with Vehicle BeltsAfter checking for hot Child RestraintAgainst the back Vehicle seat forwardAge Adjusting the Top Anchorage Strap Storage of Top Anchorage StrapTo Attach Top Anchorage Strap Belt-Positioning Booster Use HookRemoval of Harness Slots from the frontPull harness out of shell Belt-Positioning Booster Installation Reinstall Harness Stops against the shellRemoving Seat Pad for Cleaning Trouble Shooting Installation TipsWarranty Replacement Parts Order Form