Battery Caution, Parts List, To Assemble, Legs

Parts List

	C	Tools Needed:
	C	Phillips Head
		Phillips Head
		Screwdriver

A D

NOTE: Date

Code is located on back of fabric

seat.F

Hardware (Quantity):

M3 x 23mm

Phillips Head

Headrest Screw, (1)

M3 x 23mm

Phillips Head

Vibration Unit Screw, (1)

A Curved Footrest		D	Flower Toy	G	Screws (see hardware box)	J Right Leg
B	Fabric Seat (with restraint system)	E	Curved Headrest	H	Rear Leg Connector
C	Caterpillar Toy	F	Vibration Unit	I	Left Leg

To Install Batteries

1 A Locate the vibration	1
unit. Use a Phillips Head
screwdriver to remove the	A
screw on the battery door.	A
Place a C-sized battery
inside. Match the (+) and
(-) symbols according to
the diagram in battery	B
compartment.	B

B Locate the Caterpillar toy. Use a Phillips Head screwdriver to remove the

battery door. Place three

AAA-sized batteries inside. Match the the (+) and (-) symbols according to the diagram in battery compartment.

NOTE: Batteries not included.

NOTE: Vibration Unit and Caterpillar will not operate if batteries are installed incorrectly.

BATTERY CAUTION:

•Keep these instructions as they contain important information.

•DO NOT mix old and new batteries.

•DO NOT mix alkaline, standard (carbon zinc), or rechargeable (nickel-cadium) batteries.

•Non rechargeable batteries are not to be recharged.

•Rechargeable batteries are to be removed from the unit before being charged.

•Rechargeable batteries are only to be charged under adult supervision.

•Only batteries of the same or equivalent type as recommended are to be used.

•Batteries are to be inserted with the correct polarity.

•Exhausted batteries are to be removed from the unit.

•The supply terminals are not to be short-circuited.

•Check that all contact surfaces are clean and bright before installing batteries.

•DO NOT submerge any part of the product in water.

•Dispose of batteries safely.

•Remove batteries when stored for long periods of non-use.

To Assemble

1 Legs:

Line up flat edge of Right Leg with dimple on Rear Leg Connector (Figure 1). Insert leg and rotate counter clockwise.

Line up flat edge of Left Leg with dimple on Rear Leg Connector (Figure 1a). Insert leg and rotate clockwise. Tug on leg joints to check security of connections.

NOTE: The Legs are designed to fit firmly into the Headrest Frame to ensure they stay in place. As a result, you may experience some resistance when installing the Headrest Frame.

1	Rear Leg Dimple	1a Rear Leg Dimple
	Flat Edge	Flat Edge
Right Leg		Left Leg

PAGE 2