Polaroid Wireless Surveillance Camera, IP300 user manual Packing List, Product Views

Page 3

Polaroid Introduction

1.2 Packing List

After unpacking, check that the following items are in your possession:

ITEM:

QUANTITY

* IP Camera

(1)

* WI-FI Antenna

(1) (only available for wireless models)

* User Manua

(1)

* DC Power Supply

(1)

* CD

(1)

* Network Cable

(1)

NOTE: If any items are missing, contact Polaroid immediately at 1-877-836-1190

1.3 Product Views

1.3.1 Front View

 

1. Light Sensor Holes

 

2. Infrared LED

7. Wireless

3. Lens

Antenna

 

 

4. Network

 

Indicator LED

6. Speaker

 

 

5. Microphone

Figure: 1.1

1.Light Sensor Holes

2.Infrared LEDs: 16

3.LENS: CMOS sensor with fixed focus lens (Default is 3.6mm, optional 6mm available)

4.Network Indicator LED; blinks when in use

Polaroid Introduction

5.Built-in microphone

6.Speaker

7.Wireless Antenna

1.3.2 Rear Panel

Network Indicator LEDs

Antenna

Audio Output

MIC

Power

LAN

SD Card (backup) I/O Alarm

Reset

Pin

Figure: 1.2

1.LAN: RJ-45/10-100 baseT

2.Power Supply: DC 5V/2A

3.Network Lights: Glows green when connected to network, yellow when transmitting data

4.Audio Output: for external speaker

5.MIC jack for external microphone

6.I/O PINS: 1) Output A; 2) Output B; 3) Alarm input; 4) Ground Input

7.SD CARD/SIM CARD Slot: Not available for this particular MJPEG camera

8.RESET Button: to reset IPCAM to factory default parameter, press reset down and hold for 15 seconds

(keep power on when resetting camera).

4

IP300 Manual

5

 

 

 

 

Image 3
Contents Wireless Surveillance Camera Table of Contents Product Views Packing ListHardware Instruction PC System RequirementsSoftware Installation PRE-INSTALLATION Precautions IP Camera ToolSIX Options are Available VIA the IP Camera Tool Network Configuration Basic PropertiesUgrade Firmware About IP Camera Tool Camera LoginRefresh Camera List Refresh camera list manually Flush ARP BufferTo USE IE Browser to Gain Access Polaroid Software Mobile Phone Access SAFARI, FIREFOX, Google Chrome Browser AccessActivex Mode for IE Browser Access On Screen Display OSD settingsVisitor Status Operator Access Rate and ResolutionMode, Brightness, Contrast Preset PositionsAdministrator Access MULTI-DEVICE SettingsSet Multi-Device on LAN Upgrade Device Firmware Set Multi-Device on WAN using Port ForwardingBasic Network Settings Restore Factory SettingsReboot Device Network SettingsWireless LAN Settings Adsl Settings UPnP SettingsDdns Service Settings Third Party Ddns TP-LINK BelkinDlink System Settings Device InfoPT Settings Alias SettingsDate & Time Settings User SettingsIndicator Settings Backup and RestoreMSN Settings Mail Service Settings Other SettingsAlarm Settings FTP Service SettingsAlarm Input Armed/ IO Linkage on Alarm Motion Detection ArmedMotion Detection Sensitivity Trigger Level IO Pins for IO Alarm LinkageSend Mail on Alarm Upload Image on AlarmSound on Alarm Record on AlarmPath Settings Sign in mobile phone Server Push Mode for Safari, FireFox, Google BrowserIf I Need Assistance Where can I GET IT? Frequently Asked QuestionsProblems with Network BANDWIDTH?