Casio EX-S2/EX-M2 manual Rock the controller, Up or down to select Movie, and then Click

Page 47

OTHER RECORDING FUNCTIONS

 

 

3. Rock the controller

Remaining capacity

 

up or down to select

 

 

 

 

(Movie), and then

 

 

 

 

 

 

 

click.

 

 

“Remaining capacity” shows how many 30- second movies can still be recorded to memory.

Remaining recording time

4.Point the camera at the subject and then press the shutter release button.

Movie recording continues for 30 seconds, or until you stop it by pressing the shutter release button again.

The remaining recording time value counts down on the monitor screen as you record.

5.After movie recording is stopped, press the shutter release button one more time to store the movie file.

This causes the movie file to be stored into camera memory.

To cancel storage of the movie file, rock the controller down to select “Delete” while file storage is being per- formed, and then click.

IMPORTANT!

The flash does not fire in the Movie Mode.

The EX-M2 also records audio. Note the following points when recording a movie with the EX-M2.

— Take care that you do not

block the microphone with your fingers.

— Good recording results are not possible when the camera is too far from the subject.

— Operating camera buttons

Microphone

 

during recording can cause

 

button noise to be included

 

in the audio.

 

— Movie audio is recorded in

 

monaural.

 

47

Image 47
Contents EX-S2/EX-M2 Unpacking IntroductionContents Deleting Files Other Settings Transferring Files to a Computer Playing AN Audio File EX-M2 OnlyCopyright Restrictions Features EX-M2 Only General PrecautionsPrecautions Introduction Operating conditions Data Error PrecautionsLens CondensationLED Backlight Other Getting Ready Quick Start GuideTo record an image Click the controller to delete the selected image To view a recorded imageTo delete an image Front Getting ReadyCamera General GuideBottom Removing the Connector CoverUSB Cradle Using the Controller Monitor Screen Contents Play Mode Attaching the Strap Indicator LampsPower Requirements To load the batterySet the camera onto the USB cradle To charge the batteryTurn off the camera and remove its connector cover Getting Ready If the camera does not work normally Battery Life GuidelinesIf the camera works normally Low Battery Indicator Tip to Make the Battery Last LongerUSB Cradle and AC Adaptor Precautions Power Supply PrecautionsBattery Precautions Turning the Camera On and Off Auto Power Off APOMenu Screen Operations Using the On-screen MenusPress Menu Next, do either of the following Configuring Display Language and Clock Settings Getting Ready Recording an Image Basic Image RecordingRecording Precautions About the REC Mode Monitor ScreenUsing Zoom Using the Flash About Red-eye Reduction Flash PrecautionsUsing the Self-timer Specifying Image Size and Quality To specify the image sizeTo specify the image quality Exposure Compensation EV Shift Other Recording FunctionsREC mode, press Menu Adjusting the White BalanceProce- dure under Adjusting the White Balance, select Manual Adjusting White Balance ManuallyClick the controller Using the Best Shot ModeUsing the Movie Mode Up or down to select Movie, and then Click Rock the controllerRecording Audio EX-M2 Only Adding Audio to a SnapshotPress the shutter release button to start audio recording Recording Your VoicePress the shutter release button to start voice recording Audio Recording PrecautionsTurning Image Review On and Off REC Mode Camera SettingsTurning the Monitor Screen On and Off Assigning Functions to the Controller Specifying Power On Default Settings Basic Playback Operation PlaybackPlaying an Audio Snapshot EX-M2 Only Press Menu to return the image to its original size Zooming the Displayed ImageResizing an Image Playing a Movie Play modeAdding Audio to a Snapshot EX-M2 Only To re-record audio Playing Back a Voice Recording File EX-M2 Only Press Menu to exit the menu screen Deleting FilesDeleting a Single File Click the controller to delete the fileClick the controller to delete all the files Deleting All FilesFolders File ManagementMemory Folders and Files Protecting Files To protect a single fileTo protect all files in memory Dpof Settings File NameTo insert the date during printing To configure print settings for a single imageClick the controller to complete the procedure To configure print settings for all imagesExif Print Print Image MatchingTo copy a file to the Favorite folder Using the Favorite FolderTo delete a file from the Favorite folder To display a file in the Favorite folderSpecifying an Image for the Startup Screen Other SettingsTurning the Key Tone On and Off Click to register the settings and exit the set- ting screen Changing the Date and Time SettingChanging the Display Language Changing the Date FormatPage Using a Memory Card To remove a memory card from the camera Using a Memory CardTo insert a memory card into the camera Formatting a Memory Card Copying Files Memory Card PrecautionsTo copy all the files in built-in memory to a memory card To copy a file from a memory card to built-in memory Photo Loader for Windows/Macintosh Using the Camera with a ComputerInstalling the Software from the CD-ROM About the bundled CD-ROMMacintosh Computer System RequirementsWindows Selecting a Language Installing Software from the CD-ROM in WindowsGetting Started Installing an Application Viewing the Contents of the Read me FileOn the menu screen, click Exit to exit the menu Installing SoftwareInstalling Software from the CD-ROM on a Macintosh Exiting the Menu ApplicationTo install Acrobat Reader To install Internet Explorer and Outlook ExpressTo install Photo Loader To uninstall the USB driver Installing the USB DriverTo read the Photo Loader user’s guide To view the camera user’s guideTransferring Files to a Computer Transferring Files Over a USB Connec- tionTo connect the USB Cable Turn off the camera and remove its connector cover Terminating a USB Connection Using a Memory Card to Transfer Images to a ComputerDCF Protocol Using a Commercially Available SD Memory Card Reader/WriterMemory Data Directory Structure Folder and File ContentsMemory Directory Structure Image Files Supported by the Camera Built-in Memory and Memory Card PrecautionsTransferring Audio Files to the Camera Playing AN Audio File EX-M2 OnlyPlaying AN Audio File EX-M2 Only Align the mode selector with AudioPreparing the Camera for Audio Player Operation General Guide Using the Camera as an Audio PlayerLCD Remote Controller Playing AN Audio File EX-M2 Only Display 100 Basic Remote Controller OperationsAudio mode, start audio playback Specifying the Audio Playback ModeSelecting a Specify Track for Playback 101102 Specifying the Track Playback SequenceExample Folder Structure Example PLAYLIST.TXT File Contents103 104 Disabling Remote Controller Button Operations105 LCD Remote Control Error MessagesAudio Playback Precautions Menu Reference Appendix106 Play tab menu Camera Indicator LampsIndicator Lamp Reference 107108 Audio Mode EX-M2 only109 USB Cradle Indicator Lamps110 Troubleshooting Guide111 112 113 Display MessagesCamera Functions Main SpecificationsSpecifications 114Exposure Control 115Audio Player Function EX-M2 Only Power Supply116 USB Cradle LCD Remote Controller Bundled with EX-M2 Only117 Other