PLAYBACK
To re-record audio
1.In the PLAY mode, rock the controller left or right to scroll through snapshots until the one whose audio you want to
2.Select the “PLAY” tab, select “Dubbing”, and then rock the controller to the right.
3.Rock the controller up or down to select “Delete”, and then click.
•If you merely want to delete the audio with
4.Press the shutter release button to start audio recording.
5.Recording stops after about 30 seconds or when you press the shutter release button.
•This deletes the previous recording and replaces it with a new one.
IMPORTANT! 
•Keep the microphone on the front of the camera pointed at
the subject.
• Take care that you do not block the microphone with your fingers.
Microphone
•Good recording results are not possible when the camera is too far from the subject
•Operating camera buttons during recording can cause button noise to be included in the audio.
•The 
(Audio) icon appears on the monitor screen after audio recording is complete.
•You will not be able to record audio when remaining memory capacity is low.
•The following types of audio recording are not sup- ported.
—Adding audio to a movie image
—Adding audio to a protected snapshot (page 65)
•Audio that is
60