3.2.7 Direct Camera Control/Serial Port Speeds
CAMERA DIRECT CONTROL
>COM 1 PELCO COM 2 PELCO
Intercept® receiver/drivers can be connected directly to the
The receiver/drivers are connected to COM 1 and/or COM 2. Up to 16 cameras can be connected to a single COM port, giving a maximum of 32.
Use Figure 6 as a guide for the physical connection of receiver/drivers and associ- ated cameras to the
1.As before, enter direct setup by setting DIP switch 2 to the ON position, then enter you setup PIN number; the main menu screen, “SETUP MODE”, will appear.
2.Press the multipurpose key under the 
icon and advance to the “Ad- vance Setup 1” screen.
3.Use 
and 
to navigate to the “host” row and use the arrow keys
( 
, 
) to select “Direct Cam Ctrl.”
4.Use the 
key to go to COM 1 and/or COM 2 and setup the keyboard COM ports for the correct baud rate. Save, then Exit this screen to return to the main menu “SETUP MODE” screen.
COM 2 | COM 1 | |
POWERPAK |
| |
PIN 1 TX+ | PIN 1 TX+ | |
PIN 2 TX- | ||
PIN 2 TX- | ||
| ||
PELCO | ||
RECEIVER/ | RECEIVER/ | |
DRIVER | DRIVER | |
RECEIVER/ DRIVER
RECEIVER/ DRIVER
DIRECT MODE HOOKUP (REMEMBER THAT TX+ GOES TO RX+ AND TX- GOES TO RX- WHEN CONNECTING YOUR WIRES.)
RECEIVER/ | UP TO SIXTEEN (16) | UP TO SIXTEEN (16) | RECEIVER/ | |
RECEIVER/DRIVERS | RECEIVER/DRIVERS | |||
DRIVER | ||||
DRIVER | ||||
| AND ASSOCIATED | AND ASSOCIATED | ||
|
| |||
| CAMERA INPUTS | CAMERA INPUTS |
|
Figure 6. Direct Mode Hookup
12 | Pelco Manual C540M (6/98) |