JAI TM/TMC-4200CL operation manual Video Depth, Image Pre-Processing, Ctrl Signals

Page 13

Graphical User Interface

Tap Selection:

The TM-4200CL is capable of Dual-Tap or Single-Tap operation. Click the option button for the operation you prefer. Single-Tap operation does not allow the higher data rate permitted by the Dual- Tap output.

FIGURE 20. Click the corresponding option button to set the tap.

3.3.5Video Depth

Use the option buttons to select 8-bit, 10-bit, or 12-bit output.

FIGURE 21. Click the option button to select Video Depth.

3.3.6Image Pre-Processing

To activate this control click the “Blemish Calibration” button and then check the “Enable Blemish Compensation” check box. The blemish compensation activates. The lens must be covered with the lens cap during calibration.

Note: Blemish Calibration is necessary only after a camera has been powered off and restarted. Once enabled, blemish compensation remains active unless the user unchecks the “Enable Blemish Compensation” checkbox.

FIGURE 22. Checking “Enable Blemish Compensation” activates Image Pre- Processing.

3.3.7Ctrl Signals

Use the option buttons to select the control signal that matches your cabling setup, either CL or 12Pin

FIGURE 23. Set “Ctrl Signal” by clicking the option button matching your cabling.

Dual-Tap TM-4200CL AccuPiXEL Series Camera-Control Software