JAI CV-M10 Locations of Jumper, Location of Jumper on PK8189A, Location of Jumper on PK8187A

Page 15

CV-M10BX/CV-M10RS

8.6. Locations of Jumper

Jumpers positions are shorted with a 0 ohm resistor or by a soldering between the 2 points. To remove the solder tin from a jumper position, use a special tin remover such as desolder wick.

8.6.1. Location of Jumper on PK8189A

On this board the jumpers for HD/VD input, output and 75ohm termination are found.

JP6 JP4JP5

JP3

JP1 JP7

8.6.2. Location of Jumper on PK8187A

On this board the jumpers for alternative outputs on the 12 pin connector are found.

R21

R27

R26

R20

R19

- 12 -

Image 15

Contents CV-M10 Declaration of Conformity Table of Contents Main Features GeneralStandard Composition Locations and Functions CV-M10BXPin Multi-connector DC-IN/SYNC Pin Multi-connector RS 232C/TRIGGERPin Assignment Functions and Operation Input/Output of HD/VD SignalInput of External HD/VD signals Output of Internal HD/VD signalsExternal Trigger Mode Edge Pre-select Trigger ModePulse Width Control Trigger Mode Pre-select 7HD14HD Mode Setting by Switch Mode SettingsScanning Mode Shutter Time selectTrigger select Gamma Correction Gain Control/RS 232C controlCV-M10RS Serial Interface for Controls Jumper settings Locations of Jumper Location of Jumper on PK8189ALocation of Jumper on PK8187A Location of Jumper for CV-M10RS on PK8190A Location of Jumper for CV-M10BX on PK8206APotentiometer locations on PK8206A Internal adjustments on BXCV-M10RS Camera Control Tool Levels Window Files and Camera Communication Window 140.57 700 References PrecautionsTypical CCD Characteristics AppendixRevision Revision F Serial No User’s RecordIndex Camera type2700- 11052 E F3