JAI CV-M10 operation manual 7HD, Pre-select

CV-M10BX/CV-M10RS

The resulting video signal will start to be read out after the trigger rising edge. The WEN pulse indicates the start of valid video signal. Refer to timing charts for details.

A new trigger pulse must not be applied before the video read out has been finished.

To use this mode:
Set:	SW1-4 on BX rear to OFF for random trigger. For RS select trigger mode
	JP12 on PK8206 (BX ver.) or PK8190 (RS ver.) Short for Pulse Width Control
	JP13 on PK8206 (BX ver.) or PK8190 (RS ver.) OPEN for H Reset
	JP13 on PK8206 (BX ver.) or PK8190 (RS ver.) Short for H Non Reset
	SW1-1 through SW1-3 on BX rear to ON (1/10,000) For RS select 1/10,000
	and SW1 on (BX) PK8206 for Normal shutter.
Note:	For CV-M10RS the selection of Edge Pre-select, Pulse Width Control H Reset and H non-reset cannot be done by
	RS232C. In Pulse Width Control Mode the shutter speed must be set at 1/10000 sec.
	(See chapt r 7 and 8 for details)

6.4EdgeINTXSTRIG. UBTimingHDpreselectdiagramHDmodeRESET(Hresetfor Edge)		Pre-select
WENG	exposuretime
2:1interlaceinfieldaccumulation
VIDEO1	inframeaccumulation	7HD	EIA:247HD	CCIR:291HD
NonVIDEOinterlace2
EdgeVIDEOpre1selectmode(HNonReset)		14HD	EIA:494HD	CCIR:582HD
TRIG
EXTUBED
XSG	exposuretime
WEN
2:1interlaceinfieldaccumulation		7HD	EIA:247HD	CCIR:291HD
VIDEO1
NonVIDEOVIDEOinterlace12 inframeaccumulation		14HD	EIA:494HDCCIR:582HD

- 6 -