Pioneer DEH-P9800BT operation manual Understanding auto TA EQ error messages, Message Cause Action

Additional Information

Understanding built-in CD player error messages

When you contact your dealer or your nearest Pioneer Service Center, be sure to record the error message.

Message	Cause	Action
ERROR-11, 12,	Dirty disc	Clean disc.
17, 30
ERROR-11, 12,	Scratched disc	Replace disc.
17, 30
ERROR-10, 11,	Electrical or me-	Turn the ignition
12, 15, 17, 30,	chanical	ON and OFF, or
A0		switch to a differ-
		ent source, then
		back to the CD
		player.
ERROR-15	The inserted disc	Replace disc.
	does not contain
	any data
ERROR-23	The CD format	Replace disc.
	cannot be played
	back
NO AUDIO	The inserted disc	Replace disc.
	does not contain
	any files that can
	be played back
Track Skipped	The inserted disc	Replace disc.
	contains WMA
	files that are pro-
	tected by DRM
PROTECT	All the files on	Replace disc.
	the inserted disc
	are secured by
	DRM

Appendix

pears, refer to the table below to see what the				English
problem is and the suggested method of cor-
recting the problem. After checking, try again.
	Message	Cause	Action
Check MIC	Microphone is	Disconnect the mi-
type		connected to mi-	crophone.
		crophone input.
MIC ERROR		Microphone is	Plug the supplied
		not connected.	microphone se-
			curely into the
			jack.
Front Speaker		The microphone	! Confirm that the
ERROR, Front		cannot pick up	speakers are con-
left Speaker		the measuring	nected correctly.
ERROR, Front		tone of a speaker.	! Cancel muting
right Speaker			the front speaker
ERROR, Rear			units.
left Speaker			! Correct the input
ERROR, Rear			level setting of the
right Speaker			power amp con-
ERROR, Sub-			nected to the
woofer			speakers.
ERROR, Sub-			! Set the micro-
woofer Lch			phone correctly.
ERROR, Sub-
woofer Rch
ERROR
Noise ERROR		The surrounding	! Stop your car in
		noise level is too	a place that is as
		high.	quiet as possible,
			and switch off the
			engine, air condi-

tioner or heater. ! Set the micro- phone correctly.

Understanding auto TA and

EQ error messages

When correct measurement of car interior acoustic characteristics is not possible using the auto TA and EQ, an error message may ap- pear on the display. If an error message ap-

En 103