Pioneer DEH-P9800BT Adjusting the brightness, Switching the sound muting/attenuation

Section

15 Initial Settings

2Press MULTI-CONTROL to turn dimmer

on.

ON appears in the display.

# To turn dimmer off, press MULTI-CONTROL again.

Adjusting the brightness

You can adjust the display brightness. Initially this mode is set to 24.

1Use MULTI-CONTROL to select Brightness.

Brightness appears in the display.

2Push MULTI-CONTROL left or right to adjust the brightness level.

Each time MULTI-CONTROL is pushed left or right, brightness level increases or decreases.

0to 31 is displayed as the level is increased or

decreased.

# When dimmer is functioning, the brightness level can be adjusted 0 to 21.

Switching the sound muting/attenuation

Sound from this system is muted or attenu- ated automatically when the signal from the equipment with mute function is received.

!The sound is muted or attenuated, MUTE or ATT are displayed and no audio adjust- ment is possible.

!Sound from this system returns to normal when the muting or attenuation is can- celed.

1Use MULTI-CONTROL to select Mute. Mute appears in the display.

2Press MULTI-CONTROL to select the de- sired setting.

Press MULTI-CONTROL repeatedly to switch between the following settings:

!TEL mute – Muting

!10dB ATT – Attenuation

!20dB ATT – Attenuation (20dB ATT has a stronger effect than 10dB ATT)

Correcting distorted sound

When listening to a CD or other source on which the recording level is high, setting the equalizer curve level to high may result in dis- tortion. You can switch the digital attenuator to low to reduce distortion.

!Sound quality is better at the high setting so this setting is usually used.

1Use MULTI-CONTROL to select Digital ATT.

Digital ATT appears in the display.

2Press MULTI-CONTROL to select the di- gital attenuator level.

Pressing MULTI-CONTROL repeatedly will

switch between High (high) and Low (low) and that status will be displayed.

Switching the feature demo

The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON.

1Use MULTI-CONTROL to select Demonstration.

Demonstration appears in the display.

2Press MULTI-CONTROL to turn the fea- ture demo on.

ON appears in the display.

# To turn the feature demo off, press MULTI-CONTROL again.

96 En