Pioneer DEH-P9800BT operation manual Setting the high pass filter for front speakers

Audio Adjustments

!If you mute the selected speaker unit (fil- ter), MUTE ON is displayed and no adjust- ments are possible.

!Even if any speaker unit (filter) is muted, you can adjust the parameters for other speaker units (filters).

1Use MULTI-CONTROL to select Front HPF (or Rear HPF).

Front HPF (or Rear HPF) appears in the dis- play.

2Push and hold MULTI-CONTROL down to mute the selected speaker unit (filter).

MUTE ON is displayed.

# To cancel the muting, push MULTI-CONTROL up.

Setting the high pass filter for front speakers

1Use MULTI-CONTROL to select Front HPF.

Front HPF appears in the display.

2Push MULTI-CONTROL left or right to select slope.

Each time MULTI-CONTROL is pushed left or right, slopes are selected in the following order:

–12— –6—Pass (0) (dB/oct.)

# If you set the slope to 0 dB/oct. (Pass), the audio signal bypasses the filter, so the filter does not have an effect.

3Turn MULTI-CONTROL to select

Front HPF FREQ.

Front HPF FREQ. appears in the display.

4Push MULTI-CONTROL left or right to select cut-off frequency.

Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order:

Section

14

50—63—80—100—125—160—200 (Hz)	English
Only frequencies higher than those in the se-
lected range are output from the front speak-
ers.

5Push MULTI-CONTROL up or down to adjust the output level of the front speak- ers.

Each time MULTI-CONTROL is pushed up or down, the level of the front speakers increases or decreases. 0 to –24 is displayed as the level is increased or decreased.

Setting the high pass filter for rear speakers

1Use MULTI-CONTROL to select Rear HPF.

Rear HPF appears in the display.

2Push MULTI-CONTROL left or right to select slope.

Each time MULTI-CONTROL is pushed left or right, slopes are selected in the following order:

–12— –6—Pass (0) (dB/oct.)

# If you set the slope to 0 dB/oct. (Pass), the audio signal bypasses the filter, so the filter does not have an effect.

3Turn MULTI-CONTROL to select

Rear HPF FREQ.

Rear HPF FREQ. appears in the display.

4Push MULTI-CONTROL left or right to select cut-off frequency.

Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order:

50—63—80—100—125—160—200 (Hz) Only frequencies higher than those in the se- lected range are output from the rear speak- ers.

En 85