Pioneer DEH-P9800BT Audio Adjustments, Using subwoofer output, Adjusting the time alignment

Audio Adjustments

Adjusting the time alignment

You can adjust the distance between each speaker and the selected position.

!An adjusted time alignment is memorized in Custom.

1Use MULTI-CONTROL to select TA Mode.

TA Mode appears in the display.

2Press MULTI-CONTROL to select a unit of distance.

Each press of MULTI-CONTROL selects the unit of distance in the following order:

cm (centimeter)—inch (inch)

3Use MULTI-CONTROL to select

Time Alignment.

Time Alignment appears in the display.

#Can't adjust TA. Set position FL/FR appears when neither Front Left nor Front Right is se- lected in the position selector mode (Position).

#When selecting OFF in TA Mode, you cannot switch to Time Alignment.

4Push MULTI-CONTROL left or right to select the speaker to be adjusted.

Each time MULTI-CONTROL is pushed left or right, the speaker is selected in the following order:

1 2

6 5 4 3

1Front speaker left

2Front speaker right

3Rear speaker right

4Subwoofer right

5Subwoofer left

6Rear speaker left

Section

14

Front speaker left—Front speaker right—Rear	English
speaker right—Rear speaker left—Subwoofer

left—Subwoofer right

#You cannot select subwoofer left and subwoo- fer right when the subwoofer output is off.

5Push MULTI-CONTROL up or down to adjust the distance between the selected speaker and the listening position.

Each time MULTI-CONTROL is pushed up or down, the distance increases or decreases. 400.00cm to 0.00cm is displayed as the dis- tance is increased or decreased, if you have selected centimeters (cm).

160.0inch to 0.0inch is displayed as the dis- tance is increased or decreased, if you have

selected inches (inch).

# You can adjust the distance for the other speakers in the same way.

6Press BAND to cancel the time align- ment mode.

Using subwoofer output

This unit is equipped with a subwoofer output which can be turned on or off. When a sub- woofer is connected to this unit, turn the sub- woofer output on.

The subwoofer output phase can be switched between normal and reverse.

1Use MULTI-CONTROL to select Subwoofer1.

Subwoofer1 appears in the display.

2Press MULTI-CONTROL to turn subwoo- fer output on.

ON appears in the display. Subwoofer output

is now on.

# To turn subwoofer output off, press MULTI-CONTROL again.

En 83