Printronix LQH-HWTM Defines the starting row for the bar code. Enter a, Enter V to select 20 cpi

Chapter 3 Bar Codes

SR	Defines the starting row for the bar code. Enter a
	value ranging from row 1 to one less than the
	length of the form. Character row or dot row is
	specified based on the Scale command (page 83),
	or use the CP.DP format (page 26).
SC	Defines the starting column of the bar code. Enter a
	value ranging from column 1 to one less than the
	width of the form. Character column or dot column
	is specified based on the Scale command (page
	83), or use the CP.DP format (page 26).

(D)The printable character (delimiter) identifying the start and finish of the data field. Enter any printable character other than a slash (/), the SFCC, or a character used within the data. The same character must be used at both ends of the data field, but it is not printed with the data.

data field	Contains the bar code characters. A null data field
	(no characters) is permitted. The data field can
	contain any of the characters listed in Table 9
	except the SFCC. The length of the data field is
	variable; however, the maximum length is usually
	limited to 32 characters to minimize potential
	reading errors.
PDF	Optional parameter to enable printing of the human
	readable data field. Enter PDF to print the data
	field. If the parameter is not used, the human
	readable data will not print. This parameter is not
	allowed if a null data field is specified.
LOC	Optional parameter to identify the location of the
	printable data field. The default value is B, locating
	the human readable data below the bar code. A
	locates the printable data field above bar code. To
	compensate for printing the 0.1-inch high data, the
	height of the bar code body is reduced 0.1 inch.
FONT	Optional parameter to select the font for the human
	readable data field. Enter O to select OCR-A font;
	enter X to select OCR-B font; enter N to select 10
	cpi; enter P to select 12 cpi; enter Q to select 13
	cpi; enter R to select 15 cpi; enter T to select 17 cpi;
	enter V to select 20 cpi.
STOP	Ends the Bar Code command while the IGP/PGL
	continues in the Create Form Mode. Enter STOP. If
	STOP is not entered, an error message results.

94