Printronix LQH-HWTM manual Code UCC-128 Command Format, Barcode

UCC/EAN-128

Code UCC-128 Command Format

BARCODE

UCC-128; [DIR;] [MAG;] [Hn[.m];] [BFn;L;] [DARK;] SR; SC [(D)data field(D)]

[PDF [;LOC] [;FONT] ]

STOP

BARCODE	The Bar Code command; enter BARCODE.
UCC-128	Designates bar code type Code UCC/EAN-128;
	enter UCC-128.
DIR	Optional parameter that allows for rotating a
	barcode. Enter CW for clockwise rotation. Enter
	CCW or VSCAN for counter-clockwise rotation.
	Enter INV for inverted rotation. If DIR is not
	entered, the barcode is horizontally oriented.
MAG	Optional parameter to magnify the bar code symbol
	by increasing the width of the bars and spaces. The
	magnification default value is X1. Increasing the
	magnification adjusts printed character density as
	shown in Table 8. You can also use XR as defined
	on page 89. You must specify eight digits for
	variable ratio. They stand for the widths of
	alternating bars and spaces from the narrowest to
	the widest. Note that a valid UCC/EAN-128 bar
	code can be no larger than 165 mm (6.5 inches)
	wide.
Hn[.m]	Optional parameter to adjust the overall height of
	the bar code symbol (including the upper and lower
	0.1 inch guard bands and any human-readable
	data). Height adjustments are made in 0.1 inch
	increments; enter H and a value from 3 through 99
	to select height adjustments from 0.3 through 9.9
	inches. The default value is 0.9 inch. The [.m]
	provides an additional number of dots for the bar
	code height. (Dots are in the current scale).

Note If 0.3 inches is the selected height, the PDF cannot be included.

BFn;L Optional parameters for assigning a dynamic bar code data field location on a form and for designating the length of the data field. With these parameters, the actual data for the bar code data field is dynamically provided during the Execute Form mode; the data is not specified during the Create Form mode. To use this field, perform the following steps:

a.Enter BF.

179