Creating a Logo

Creating a Logo

1.Use your system commands to open a file for the logo program with the filename HNDLGO.FOM. For example:

Enter

Format

HNDLGO.FOM

(System Format)

2.Input the Special Function Control Character and Logo mode command to put the IGP in the Create Logo mode. Include HAND as the logo name; specify a vertical length (VL) of 56 (column length) and a horizontal length (HL) of 60 (row length).

Enter

Format

~LOGO;HAND;56;60

(cc)LOGO;logoname;VL;HL

3.Enter each row of dot positions as tabulated from the grid and shown in Figure 54. The format is Row;Column (for example, 15;13-29;36-51). Each row is entered on a separate line. After all the dot positions are entered, terminate the Create Logo mode by entering an End command line.

4.Use the Special Function Control Character and Create command to create a form with the form name LEFTHAND. To add the logo to the form, input a Create Form mode Logo Call command, identify the logo starting row (SR) 45 and starting column (SC) 33, and specify the logo to use by its name (HAND). Stop the Logo command and end the Create Form mode.

EnterFormat

~CREATE;LEFTHAND

(cc)CREATE;[/]formname[;FL]

LOGO

LOGO

45;33;HAND

SR;SC;logoname

STOP

STOP

END

END

5.Input the Special Function Control Character and Execute command for the LEFTHAND form just created. Input a blank line, the Special Function Control Character, and the Normal command to instruct the IGP to return to the Normal mode after execution.

Enter

Format

~EXECUTE;LEFTHAND

(cc)EXECUTE;formname[;PAGE n]

 

[;FC]

~NORMAL

(cc)NORMAL

6.Use system commands to exit the HNDLGO.FOM file and print. The finished program and logo should look like the following sample. If error messages occur, refer to “Solving Program Errors” on page 248.

~LOGO;HAND;56;60 1;40-42 2;38-42 3;36-42 4;35-42 5;33-41 6;31-40 7;30-38 8;29-36 9;28-35

237

Page 237
Image 237
Printronix LQH-HWTM manual Creating a Logo, CcLOGOlogonameVLHL, SRSClogoname