Printronix LQH-HWTM manual 201

UPCSHIP

d. The information for the data field is entered

	dynamically during the Execute Form Mode.
	(Refer to “Execute Form: Dynamic Bar Code
	Data” on page 63.) Do not use the data field
	parameter to enter data when the BFn
	parameters are used. However, refer to the
	data field description for available characters.
DARK	Optional parameter to produce darker looking bar
	codes. Enter DARK. Refer to “Dark Printing” on
	page 28 for more information.
SR	Defines the starting row for the bar code. Enter a
	value ranging from row 1 to one less than the
	length of the form. Character row or dot row is
	specified based on the Scale command (page 89),
	or use the CP.DP format (page 26).
SC	Defines the starting column of the bar code. Enter a
	value ranging from column 1 to one less than the
	width of the form. Character column or dot column
	is specified based on the Scale command (page
	89), or use the CP.DP format (page 26).

(D)The printable character (delimiter) identifying the start and finish of the data field. Enter any printable character other than a slash (/), the SFCC, or a character used within the data. The same character must be used at both ends of the data field, but it will not print with the data.

data field	The barcode data. The UPCSHIP barcode requires
	exactly 13 characters of data. The available
	characters are 0 through 9 (hex 30 through hex 39).
	The modulo-10 check digit is automatically included
	in the barcode.
PDF	Optional parameter to enable printing of the human
	readable data field. Enter PDF to print the data
	field. If the parameter is not used, the human
	readable data is not printed.
LOC	Optional parameter to identify the location of the
	printable data field. The default value is B, locating
	the human readable data below the bar code. A
	locates the printable data field above bar code. To
	compensate for printing the 0.1-inch high data, the
	height of the bar code body is reduced 0.1-inch.

201