Printronix LQH-HWTM manual Lines, Horizontal, Format Horz

Chapter 2 Command Codes

Lines, Horizontal

Purpose Defines horizontal lines.

Mode CREATE

Format HORZ

LT; R; SC; EC

STOP

HORZ	The Horizontal Line command; enter HORZ.
LT	Defines the line thickness, measured in 1/72-inch
	dots. Enter a value of 1 or greater. Horizontal line
	thickness expands downward from the given row.

RDefines the row to draw the horizontal line. Enter a value ranging from row 1 through one less than the length of the form. Character row or dot row is specified based on the Scale command (page 83), or use the CP.DP format (page 26).

SC	Defines the starting column of the horizontal line.
	Enter a value ranging from column 1 through one
	less than the width of the form. Character column
	or dot column is specified based on the Scale
	command (page 83), or use the CP.DP format
	(page 26).
EC	Defines the ending column of the horizontal line.
	Enter a value ranging from column 2 through the
	last column of the form. The ending column must
	be greater than the starting column. Character
	column or dot column is specified based on the
	Scale command (page 83), or use the CP.DP
	format (page 26).
STOP	Stop indicates the end of the HORZ command;
	enter STOP. If not entered, the IGP expects
	another set of Horizontal Line command
	parameters.

Example The following example specifies 2 horizontal lines. The first line uses the character row in the R parameter, and the second line uses CP.DP format. To illustrate positioning, the starting row and column are indicated on the example but do not necessarily reflect actual location on the page.

HORZ 1;60;15;65 1;60.5;15;65

STOP

COLUMN 15 COLUMN 65

ROW 60

ROW 60.5

72