Printronix LQH-HWTM manual Corners, Stop Corner

Corners

Corners

Purpose	Defines corner sets.
Mode	CREATE
Format	CORNER
	LT; SR; SC; ER; EC; VL; HL
	STOP
	CORNER	The Corner command; enter CORNER. Corners
		expand down and to the right from the given row
		and column.
	LT	Defines the line thickness, measured in dots. Line
		thickness is based on dot dimensions of 1/72 inch
		both horizontally and vertically, so that line
		thickness is equal in both directions. Enter a value
		of 1 or greater.
	SR	Defines the starting row of the corner. Enter a value
		ranging from row 1 through one less than the length
		of the form. Character row or dot row is specified
		based on the Scale command (page 83), or use the
		CP.DP format (page 26).
	SC	Defines the starting column of the corner. Enter a
		value ranging from column 1 through one less than
		the width of the form. Character column or dot
		column is specified based on the Scale command
		(page 83), or use the CP.DP format (page 26).
	ER	Defines the ending row of the corner. Enter a value
		ranging from row 2 through the last row of the form.
		The ending row must be greater than the starting
		row. Character row or dot row is specified based on
		the Scale command (page 83), or use the CP.DP
		format (page 26).
	EC	Defines the ending column of the corner. Enter a
		value ranging from column 2 through the last
		column of the form. The ending column must be
		greater than the starting column. Character column
		or dot column is specified based on the Scale
		command (page 83), or use the CP.DP format
		(page 26).
	VL	Defines the length of the vertical arm (including the
		line thickness) of each corner in the set. Enter a
		value of 1 or greater specified in character or dot
		rows based on the Scale command (page 83), or
		use the CP.DP format (page 26).
	HL	Defines the length of the horizontal arm (including
		the line thickness) of each corner in the set. Enter a
		value of 1 or greater specified in character or dot
		columns based on the Scale command (page 83),
		or use the CP.DP format (page 26).

49